Abstract:This article presents a system for easing the characterization of probe-fed antennas on available probe stations. Many of these stations were deployed for scattering parameter measurement but not for radiation pattern acquisition. Furthermore, these latter acquisitions have traditionally required the use of mechanical positioners for the automated movement of the probe antenna along different surfaces. Integration of these mechanical systems can be complex in some probe stations due to physical constraints. This work proposes an easy-to-deploy freehand system for amplitude-only field acquisitions providing great flexibility for probe-fed antenna diagnostics. In addition, the use of feeding probes, which can be bulky if compared to low-gain antennas is known to result in partial blocking avoiding the acquisition of the radiation pattern for some angles and for causing reflections yielding some ripple and distortion in the measured pattern. The system benefits from a near-field (NF) to far-field (FF) transformation based on the source reconstruction method so that unwanted reflections can be spatially identified and filtered out. Finally, broadband phaseless acquisition based on interferometry is implemented. This technique enables to alleviate the requirements of a full-vector (i.e., amplitude and phase) acquisition without losing information regarding the time-domain behavior and to retrieve all the frequencies simultaneously without losing the coherence between them so that parameters such as the delay spread can be measured. Simulated and experimental results in the V-band from 57 to 66 GHz are analyzed to validate the proposed system. Results are in fair agreement with both simulations and a direct FF acquisition on a conventional automated spherical system used as a reference.

Radiation behaviour of mm‐wave on‐wafer probes in H‐band and the influence on antenna measurements

Probe-Fed Millimeter-Wave and Subterahertz Antenna Measurements: Challenges and solutions

Uncertainties Introduced by the Probe in Millimeter-Wave Planar Near-Field Measurements

MMIC on-Wafer Test Method Based on Hybrid Balanced and Unbalanced RF Pad Structures

Investigation of Multilayer Print Circuit Board Probe with Temperature Compensation for Ultra-Wideband Near-Field Measurement

Design of Microstrip Line used for Probe Calibration up to 40 GHz

A Wideband and High Sensitivity Probe Design for Near-Field Scanning

Importance and Requirement of Frequency Band Specific RF Probes EM Models in Sub-THz and THz Measurements up to 500 GHz

Rigorous characterization of EMC antennas

A Miniature Multi-Component Probe for Near-Field Scanning

Probe Design and Source Reconstruction for Near-Field Scanning and Modeling

A Novel Four-Port Symmetric Probe Calibration Method for On-Wafer S-Parameter Measurement

A Wideband Antenna for Mm-Wave Antenna-in-Package Application

Multiprobe-Enabled Over-the-Air Calibration of Millimeter-Wave Antenna Arrays: Concepts and experimental validations

Conformal antenna array for millimeter-wave communications: performance evaluation

A Multiantenna System With High Isolations for Millimeter-Wave Sensing

Printed tapered leaky-wave antennas for W-band frequencies

A Reverberation Chamber for Antenna Measurements up to 140 GHz

Investigation Of Planar Near-Field Measurement Of Millimeter-Wave Antenna For 5g Application

Comparative Analysis of Several Near-Field Probes for Magnetic Field Measurements

Freehand System for Probe-Fed Antenna Diagnostics by Means of Amplitude-Only Acquisitions