Abstract:This study aims to investigate the effect of rare earth (RE) elements on the microstructure and mechanical properties of bainite/martensite (B/M) bearing steel. For this purpose, GCr15 bearing steels with different RE contents were prepared and analyzed after experiencing B/M heat treatment. The results show that RE addition significantly delays the bainite transformation by reducing grain boundary energy and carbon diffusion rate, leading to a reduction of bainite volume fraction from 27.3% for bearing steel without RE addition to less than14.5% for RE-treated steels, and the corresponding increase of martensite volume fraction from 39.1% to more than 50.2%. The volume fraction of retained austenite (RA) remains nearly unchanged. Meanwhile, the width of the bainite needles gets refined in RE-treated steels while martensite and RA blocks become bigger. Compared with bearing steel without RE addition, larger RA blocks in RE-treated steels unexpectedly have higher stability due to higher dislocation density and surrounding phases strength. Accompanied by the change of microstructure, the hardness in RE-Treated steels improves slightly, while the fracture toughness dramatically deteriorates which can be directly explained by two mechanical phenomena during toughness test. The one is that the RA in RE-treated steels is harder to transform into martensite and thus consumes less energy; The other one gives that cracks tend to propagate along grain boundaries or martensite interfaces with less energy consumption easily in RE-treated steels instead of breaking off bainite.

Study on sliding friction and wear behavior of M50 bearing steel with rare earth addition

Rolling contact fatigue behaviour of M50 bearing steel with rare earth addition

Effect of rare earth elements on microstructure and mechanical properties of bainite/martensite bearing steel

Rare earth addition powered corrosion resistance of the surface oxide film on GCr15 bearing steel substrate

Effect of Primary Carbides on Rolling Contact Fatigue Behaviors of M50 Bearing Steel

Atomistic insights into friction and wear characteristics of M50 bearing steel: a molecular dynamics simulation study

Study on depth-related microstructure and wear property of rare earth nitrocarburized layer of M50NiL steel

Effect of rare earth addition on microstructure and corrosion behavior of plasma nitrocarburized M50NiL steel

Dry sliding wear of MA/PM Al-10Ti alloy

Influence of trace rare earth elements on very high cycle fatigue behavior of hot rolled bearing steel

Tribological Properties and Friction-Induced Noise Performance of M50 with Curved Microchannels Filled by Sn-Ag-Cu and Ti3C2

Effects of rare earth addition and service mode on surface integrity evolution of high-end machine tool spindle bearings under service

Research on Sliding Wear Behavior of Co-based Alloy Based on Experiments with Material of Pin and Disc Exchanged

Friction and wear behavior of new light steel reinforced by beryllium alloying

Wear behavior and damage characterization for AISI 52100 bearing steels: Effect of hardness and spherical carbides

Microstructure and mechanical properties of M50NiL steel plasma nitrocarburized with and without rare earths addition

Correlating numerical modelling with experimental studies to quantify the wear resistance of high-carbon chromium bearing steel in mixed lubrication

Microstructure and tribological performances of M50 bearing steel processed by ultrasonic surface rolling

Effect of rare earth addition on corrosion sensitivity of GCr15 bearing steel in marine environment