Abstract:This article investigates the influence of transient reoxidation environment on the morphology evolution of nonmetallic oxide inclusions in rare‐earth‐treated bearing steel. The higher the amount of rare earth, the more resistant the inclusion type to change with an increase in the secondary oxidation amount. The results reduce the adverse effects of rare‐earth secondary oxidation on bearing steel. The impact of transient reoxidation environments on the chemical morphology evolution of nonmetallic oxide inclusions in rare‐earth‐treated bearing steel is investigated using FactSage thermodynamic simulation calculations, vacuum induction furnace experiments, and high‐temperature laser confocal microscopy experiments. Thermodynamic calculations indicate a direct correlation between the initial rare‐earth content and the oxygen required to transform Ce2O2S to CeAlO3 during secondary oxidation. Furthermore, a higher initial rare‐earth content leads to a more extensive and complete conversion to CeAlO3. Vacuum induction furnace experiments reveal that the inclusions transform from Ce2O2S to CeAlO3 and Al2O3 and eventually into composite oxide clusters. This results in a significant increase in inclusions, with near‐spherical Ce2O2S inclusions transforming into aggregated CeAlO3, leading to an increase in the average inclusion size from 2.4 to 4.2 μm. Laser confocal scanning microscopy experiments show that CeAlO3 exhibits a higher tendency to aggregate than Ce2O2S inclusions, the primary factor contributing to the observed increase in the average inclusion size after secondary oxidation. The results of this study provide theoretical guidance for mitigating the adverse effects of rare‐earth secondary oxidation on bearing steels, particularly in terms of inclusion control.

Rare earth addition powered corrosion resistance of the surface oxide film on GCr15 bearing steel substrate

Effect of rare earth addition on corrosion sensitivity of GCr15 bearing steel in marine environment

Effects of rare earth elements addition on mechanical properties and corrosion behavior of GCr15 bearing steel under different heat treatment conditions

Study of effects of rare earth elements on the corrosion behavior of weathering steels under a simulated immersion environment and a real atmospheric environment

Corrosion behavior and kinetics model of rare earth low‐alloy steel in a soil simulation solution

Influence of Solid Chromizing Doped with Various Rare Earths on Microstructures and Properties of Cr-RE Coatings Fabricated by Pack Cementation

Effect of rare earth addition on microstructure and corrosion behavior of plasma nitrocarburized M50NiL steel

Investigation of rare earth (RE) on improving the corrosion resistance of Zr-Ti deoxidized low alloy steel in the simulated tropic marine atmospheric environment

Rolling contact fatigue behaviour of M50 bearing steel with rare earth addition

Effect of rare earth elements on microstructure and mechanical properties of bainite/martensite bearing steel

Enhanced Impact Toughness of Previously Cold Rolled High-Carbon Chromium Bearing Steel with Rare Earth Addition

Study on sliding friction and wear behavior of M50 bearing steel with rare earth addition

Effect of Rare Earth Y on Microstructure and Mechanical Properties of High-Carbon Chromium Bearing Steel

Synergistic Effect of Microalloying Elements on the Corrosion Behavior of an Industrially Produced Low-Carbon Steel

Effects of rare earth addition and service mode on surface integrity evolution of high-end machine tool spindle bearings under service

Research on the improvement and mechanism of La-Ce on inclusions in GCr15 bearing steel

Acceleration of Plasma Nitriding at 550 °C with Rare Earth on the Surface of 38CrMoAl Steel

Effect of Transient Reoxidation on Inclusions in Rare‐Earth‐Treated Bearing Steel

Effects of Modified Inclusions and Precipitates Alloyed by Rare Earth Element on Corrosion and Impact Properties in Low Alloy Steel

The effect of rare earth on microstructure and wear resistance of plasma electrolytic carburizing layer on 17–4PH stainless steel