Abstract:The crystal structures and phase compositions of Ti0.7Zr0.(3)(Cr1-xVx)(2) (x=0.1, 0.2, 0.3, 0.4) alloys are analyzed by the XRD and SEM. The hydrogen storage properties, activation performance, thermodynamics and high-temperature desorption process of the alloys are investigated by pressure-composition-temperature (P-C-T) and DTA-TG measurements. The results show that the Ti-0.7,Zr-0.3(Cr1-xVx)(2) alloys contain multi-phases, i.e. C36 (P6(3)/mmc) and C15 (Fd3m) Laves phases and V-based bcc solid solution phases with different lattice constants. When the content of V in the alloy is low, the alloy basically consists Of C36 type of Laves phase and small amount of bcc solid solution phase. As the content of V increases, the C36 type transfers into C15 type of Laves phase, where the probability of forming third type of stacking layers (C layers) increases, and the content of the bcc solid solution also increases. The alloys in bulk can be easily activated at 2 MPa and room temperature. The x=0.1, 0.2 alloys present excellent activation performance even after exposure in air for 20 d. As V content increases, the hydrogen absorption capacity of the alloy increases whereas the plateau pressure decreases. The relative partial molar enthalpy (Delta E) and entropy (Delta S) of hydrogen absorption for the alloys are found to be in the ranges of-7 similar to-28 kJ/mol and 35 95 J/(mol center dot K). The DTA-TG analysis indicates that the hydrogen release from the hydrides of the alloys occur in two dissolving temperatures within the range of 500 similar to 600 K, and some residual hydrides have completely decomposed at heating temperature up to 800 K.

Structural, morphology, and hydrogenation properties of non-stoichiometric alloy (Ti0.75 Zr0.25)1.05 Mn0.8CrTM0.2 (TM = Cr, Mo, and Nb)

Experimental and Theoretical Investigation on the Enhanced Hydrogen Storage Performance of Ti–Cr–Mn–Fe-Based Alloys Modified by Nb Substitution

Improvement on the Kinetic and Thermodynamic Characteristics of Zr1-xNbxCo (x = 0–0.2) Alloys for Hydrogen Isotope Storage and Delivery

Development of Ti–Zr–Mn–Cr-(V–Fe) Based Alloys for Hydrogen Feeding System in Hydrogen Metallurgy Application

Hydrogen Storage Properties and Crystal Structure of Ti-Cr Based Alloys

Influence of the Substitution Cr for Mn on Structural and Hydrogen Storage Performance of Ti 0.9 Zr 0.1 V 0.45 Cr X Mn 1.5-X (x=0, 0.05, 0.1, 0.15, 0.2) Alloys

Phase Structures and Hydrogen Storage Properties of TiV1.35Cr1.35-xMnx Alloys(x=0～0.45)

Phase structures and hydrogen storage properties

Effect of Mn Substitution for Co on the Structural, Kinetic, and Thermodynamic Characteristics of ZrCo1−Mn (x=0–0.1) Alloys for Tritium Storage

Hydrogen storage properties of TiMn2-based alloys

The Effect of Cr Content on the Structural and Hydrogen Storage Characteristics of Ti10V80−xFe6Zr4Crx (x = 0–14) Alloys

Hydrogen Storage Properties of Ti-Cr-Mn-M (M=V, Fe, Ni, Cu) Alloys

Hydrogen storage capabilities of the alloys Fe 0.85Mn 0.15Ti 0.9M 0.1 (M=Zr, V, Ca)

Microstructures and Hydrogen Storage Properties of Ti10V83-xFe6ZrMnx Alloys

Effect of zr content on the microstructures and hydrogen storage properties of (Ti-Cr)(45-x)V55Zrx (x=1 similar to 7) alloys

Influence of Annealing Treatment on the Microstructure and Hydrogen Storage Performance of Ti1.02Cr1.1Mn0.3Fe0.6 Alloy for Hybrid Hydrogen Storage Application

Influence of element substitution on structural stability and hydrogen storage performance: A theoretical and experimental study on TiCr2-xMnx alloy

Hydrogen Storage Properties Of(ti 0.85 Zr 0.15 ) 1.05 Mn 1.2 Cr 0.6 V 0.1 M 0.1 （m=ni,fe,cu） Alloys Easily Activated at Room Temperature

MICROSTRUCTURES AND HYDROGEN STORAGE PROPERTIES OF Ti0.7Zr0.3(Cr1-xVx)2 ALLOYS

Phase Structure and Hydrogen Storage Properties of Ti17cr23v55-Xzr5fex (X=11 Similar to 16) Alloys

Influence of Ti Super-Stoichiometry on the Hydrogen Storage Properties of Ti1+xCr1.2Mn0.2Fe0.6 (x = 0–0.1) Alloys for Hybrid Hydrogen Storage Application