Abstract:Cu/SiO2 catalyst prepared by the ammonia-evaporation (AE) method is the potential preferred catalyst for hydrogenation of dimethyl oxalate (DMO) to ethylene glycol (EG). Although significant advancements have been obtained in the confirmation and influence factors of active species in the hydrogenation process, the relationship between the catalytic activity and the sensitive factors in the preparation or pretreatment process of the catalyst is still uncertain. In this paper, Cu/ZSM-5 catalysts for DMO hydrogenation to EG were prepared by the AE method using ZSM-5 molecular sieve with high silicon-alumina ratio (1500) as a support. The ZSM-5 support was pretreated by drying at 393 K for different hours and it was found that the surface hydroxyl group of the support had significant influence on the structure and catalytic hydrogenation performance of the prepared Cu/ZSM-5 catalyst. The distribution of surface hydroxyl groups could be significantly changed by pre-drying the carrier, which further resulted in the change of the copper dispersion and surface properties of subsequent copper-supported catalysts. With the decrease of hydroxyl content on the surface of the ZSM-5 support, the prepared reduced Cu/ZSM-5 catalyst possessed smaller Cu0 particles size, higher copper dispersion, higher surface area of Cu0 and Cu+ species, but weakened surface acidity of the catalyst, which resulted in the great improvement of the catalytic activity. The DMO conversion and EG selectivity could reach 100% and 93% even under the low reaction temperature at 448 K over the Cu/ZSM-5-24 catalyst (based on the ZSM-5 support pretreated by drying for 24 h). In addition, the catalytic activity did not show obvious change after 300 h of reaction, probably due to the low temperature reaction and suitable surface properties of the catalyst.Graphical Abstract

Highly dispersed Ag2O-CuO nanospheres supported on γ-χ-Al2O3 for methanol dehydration to dimethyl ether

Highly Dispersed CrOx Nanoparticle-Modified NaZSM-5 for Dehydration of Methanol to Dimethyl Ether

Highly Dispersed Crox Nanoparticles Modified Nazsm-5 for Lower Temperature Dehydration of Methanol to Dimethyl Ether

99/00320 Effect of oxide dispersion in a bifunctional catalyst on the formation of dimethyl ether

Dehydration of Methanol to Dimethyl Ether over Γ‐al2o3 Catalyst: Intrinsic Kinetics and Effectiveness Factor

The Direct Synthesis of Dimethyl Ether from Syngas over Hybrid Catalysts with Sulfate-Modified Γ-Alumina As Methanol Dehydration Components

Regulating Surface Acid-Base Balance on NaZSM-5 by Fe Modification Towards Enhanced Methanol Dehydration to Dimethyl Ether

Promoted catalytic performance of sugarcane bagasse ash supported by γ‐alumina as efficient, stable, and ecofriendly catalyst for dehydration of methanol to dimethyl ether

Surface acidity and the dehydration of methanol to dimethyl ether

Catalytic dehydration of methanol to dimethyl ether over micro–mesoporous ZSM-5/MCM-41 composite molecular sieves

Dehydration of Methanol to Dimethyl Ether over Al2(SO4)3/SiO2 Catalysts

Reaction Kinetics of Methanol Dehydration over Combined AI203-HZSM-5 Solid Acids

Direct Synthesis of Dimethyl Ether on Supported Cu-Mn Catalysts

Cu–Mn–Al based catalyst for the direct syngas to dimethyl ether conversion

MCM-22, MCM-36, and ITQ-2 Zeolites with Different Si/Al Molar Ratios as Effective Catalysts of Methanol and Ethanol Dehydration

Micro-mesoporous Composite Molecular Sieves H-ZSM-5/MCM-41 for Methanol Dehydration to Dimethyl Ether: Effect of SiO2/Al2O3 Ratio in H-ZSM-5

Highly dispersed, ultra-small and noble metal-free Cu nanodots supported on porous SiO2 and their excellent catalytic hydrogenation of dimethyl oxalate to methyl glycolate

Non‐oxidative conversion of methanol to dimethyl ether, methyl formate and dimethoxymethane over Cu/Hβ catalyst: Tailoring product selectivity

Synthesis of highly porous nanocrystalline alumina as a robust catalyst for dehydration of methanol to dimethyl ether

Effect of Surface Hydroxyl Content of Support on the Activity of Cu/ZSM-5 Catalyst for Low-Temperature Hydrogenation of Dimethyl Oxalate to Ethylene Glycol

Synthesis of γ-Al2O3–CeO2 catalyst with high surface area, high stability, and less coke formation for methanol dehydration reaction process