Calculation of thermal parameters of SiGe microbolometers

A. V. Voitsekhovskii,D. V. Grigoryev,V. A. Yuryev,S. N. Nesmelov
DOI: https://doi.org/10.48550/arXiv.1208.6147
2012-08-30
Materials Science
Abstract:The thermal parameters of a SiGe microbolometer were calculated using numerical modeling. The calculated thermal conduction and thermal response time are in good agreement with the values found experimentally and range between 2x10$^-7$ and 7x10$^-8$ W/K and 1.5 and 4.5 ms, respectively. High sensitivity of microbolometer is achieved due to optimization of the thermal response time and thermal conduction by fitting the geometry of supporting heat-removing legs or by selection of a suitable material providing boundary thermal resistance higher than 8x10$^-3$ cm$^2$K/W at the SiGe interface.
What problem does this paper attempt to address?