Abstract:In the present study, ZrB2 nanoparticles were synthesized using sol-gel method. Zirconium alkoxide was used as the source of zirconium and boric acid as the source of boron. The size of precursor nanoparticle was controlled using the pH parameter inside the sol, and the formation of primary nuclei of ZrB2 phase and their crystallized amount were investigated using the temperature parameter. To evaluate the mechanism of product formation during the sol-gel process, TEM, SEM, DTA/TG, RAMAN, XRD, FTIR, and DLS methods were used. DLS analysis showed that the size of precursor particle inside the sol at pH less than 5 was below 10 nm. Measurements of viscosity and zeta potential inside the sol showed that in the acidic range, the particle stability decreases with increasing pH. Mixing of precursor particles at molecular level inside the sol was one of the important reasons in reducing the synthesis temperature of ZrB2 particles. FTIR analysis on chemical bonds showed that Zr-O-B bond was formed inside the gel powder. DTA analysis showed that the primary nuclei of ZrB2 particles were formed at a temperature of about 1400 °C. XRD observations proved that the primary nuclei of the ZrB2 phase crystallized and grew at a temperature of about 1500 °C. Surface research revealed that the specific surface area of the synthesized ZrB2 particles is equivalent to 115 m2/g, and also the surfaces of these particles are porous, and the size of these porosities is in meso range. SEM analysis showed that the particle size of ZrB2 having homogeneous morphology is about 50 nm. TEM microstructural analysis revealed that ZrB2 particles were formed uniformly and orderly in very fine dimensions.Graphical abstract

Aqueous sol–gel synthesis of zirconium titanate (ZrTiO4) nanoparticles using chloride precursors

In-Situ Anatase Flake Crystals Prepared By Sol-Gel Method At Low Temperature

Preparation and Properties of CaTiO_3:Zn Nanoparticles Based on Sol-Gel Method

Preparation of Zirconia Powders by Sol-gel Process

Ionothermal Synthesis and Characterization of Crystalline Zirconium Phosphate from Oxalic Acid/Tetrapropyl Ammonium Bromide System

Hydrothermal Synthesis and Characterization of Zirconia Nanocrystallites

Room‐Temperature Hydrolysis of Potassium Titanyl Oxalate and Water‐Assisted Crystallization for TiO2 with High Photocatalytic Activity

Improvement of ZrB2 nanopowder synthesis by sol-gel method via zirconium alkoxide/boric acid precursors

Facile Synthesis and Characterization of ZrO₂ Nanoparticles via Modified Co-Precipitation Method

The synthesis of nanosized TiO2 powder using a sol-gel method with TiCl4 as a precursor

Synthesis of ZnTiO3 Ceramic Powders by Sol-Gel Method

From Gel to Crystal: Mechanism of HfO2 and ZrO2 Nanocrystal Synthesis in Benzyl Alcohol

Sol–gel Synthesis of Macroporous TiO 2 from Ionic Precursors Via Phase Separation Route

ZrO2 Nanoparticles Synthesized by the Sol–Gel Method: Dependence of Size on pH and Annealing Temperature

Sol-Gel Synthesis of Zinc Alumotitanate, Monitoring of Chelation, Hydrolysis, Condensation, and Crystallization Processes

Synthesis of titanium dioxide nano-powder via sol–gel method at ambient temperature

Preparation of spherical zirconia powder by nano-reactor of microemulsion and its densification behavior

Preparation of amorphous ZrO2 powders by hydrothermal-assisted sol-gel method

Crystallization of t-ZrO2 in zirconia powder prepared by sol-gel process

Phase Composition Controllable Preparation of Zirconia Nanocrystals Via Solvothermal Method

Preparation of ZrO2 Nano-Particles by the Hydrolysis of ZrOCl2 Solution in the Reverse Micelles