Abstract:In the present study, ZrB2 nanoparticles were synthesized using sol-gel method. Zirconium alkoxide was used as the source of zirconium and boric acid as the source of boron. The size of precursor nanoparticle was controlled using the pH parameter inside the sol, and the formation of primary nuclei of ZrB2 phase and their crystallized amount were investigated using the temperature parameter. To evaluate the mechanism of product formation during the sol-gel process, TEM, SEM, DTA/TG, RAMAN, XRD, FTIR, and DLS methods were used. DLS analysis showed that the size of precursor particle inside the sol at pH less than 5 was below 10 nm. Measurements of viscosity and zeta potential inside the sol showed that in the acidic range, the particle stability decreases with increasing pH. Mixing of precursor particles at molecular level inside the sol was one of the important reasons in reducing the synthesis temperature of ZrB2 particles. FTIR analysis on chemical bonds showed that Zr-O-B bond was formed inside the gel powder. DTA analysis showed that the primary nuclei of ZrB2 particles were formed at a temperature of about 1400 °C. XRD observations proved that the primary nuclei of the ZrB2 phase crystallized and grew at a temperature of about 1500 °C. Surface research revealed that the specific surface area of the synthesized ZrB2 particles is equivalent to 115 m2/g, and also the surfaces of these particles are porous, and the size of these porosities is in meso range. SEM analysis showed that the particle size of ZrB2 having homogeneous morphology is about 50 nm. TEM microstructural analysis revealed that ZrB2 particles were formed uniformly and orderly in very fine dimensions.Graphical abstract

ZrO2 Nanoparticles Synthesized by the Sol–Gel Method: Dependence of Size on pH and Annealing Temperature

Preparation of Zirconia Powders by Sol-gel Process

The Hydrothermal Synthesis of ZrO<sub>2</sub> Nanoparticles and Their Optical Absorption Properties

Facile Synthesis and Characterization of ZrO₂ Nanoparticles via Modified Co-Precipitation Method

Effects of Water Amount and Ph on the Crystal Behavior of a TiO2 Nanocrystalline Derived from a Sol–Gel Process at a Low Temperature

The effects of annealing temperature on size, shape, structure and optical properties of synthesized zinc oxide nanoparticles by sol-gel methods

Synthesis of Single-Crystalline Pb(Zr0.52Ti0.48)O-3 Nanocrystals by Hydrothermal Method

Preparation and Properties of CaTiO_3:Zn Nanoparticles Based on Sol-Gel Method

Insight of precursor concentration, particle size and band gap of zirconia nanoparticles synthesized by co-precipitation method

Hydrothermal Synthesis and Characterization of Zirconia Nanocrystallites

Preparation of amorphous ZrO2 powders by hydrothermal-assisted sol-gel method

Improvement of ZrB2 nanopowder synthesis by sol-gel method via zirconium alkoxide/boric acid precursors

Preparation, Characterization, and Application of Zinc Oxide Nanoparticles by Sol-Gel Pyrrolysis Method: Influence of Annealing Temperature on Crystalline Phases

Thermal and structural studies of zinc zirconate nanoscale composite derived from sol–gel process

Effect of pH on structural, optical and dielectric properties of nano-zirconium oxide prepared by hydrothermal method

Synthesis, microstructure and optical characterization of zirconium oxide nanostructures

Fine Tuning of the Sizes and Phases of ZrO2 Nanocrystals

Co-precipitation of nano Mg–Y/ZrO2 ternary oxide eutectic system: Effects of calcination temperature

Effect on Nanonmeter Zinc Oxide Powders Size under Sol Preparation Condition

Optimization of the structure and morphology of monoclinic phase nanoscale zirconium dioxide

Aqueous sol–gel synthesis of zirconium titanate (ZrTiO4) nanoparticles using chloride precursors