Abstract:Desiccant cooling and drying systems have attracted considerable attention in recent years because they can enhance the quality of dried products and reduce the use of conventional source of energy. Calcium chloride (CaCl2) aqueous solution is the cheapest and most readily available liquid desiccant that could be used in desiccant cooling and drying systems, but it has the disadvantage of being instable depending on the inlet air conditions and the concentration of the desiccant in the solution. CaCl2 + LiCl (1:1 mass) and CaCl2 + Ca(NO3)(2) (5:2 mass) mixtures are thought to be the two most potential liquid desiccants with their relatively high performance and high economic efficiency. The main purpose of this research is to obtain the basic thermodynamic properties (isobaric heat capacities) of the aqueous solutions of CaCl2 and its two specially composed mixtures. The measurements were carried out at temperatures range from 308 to 348K and different concentrations determined under consideration of the working conditions of the liquids in systems. Scanning calorimetry was applied and a specialized experimental unit for heat capacity measurements of liquids was used in this research. Based on the results, semiempirical equations as functions of temperature and solute concentration were obtained. The deviation between the equations and experiment values showed good agreements, which confirmed the capability of these equations to be used in engineering applications.

Heat Capacity, Density, Vapor Pressure, and Enthalpy of Vaporization of Propyl Cinnamate

Densities and Viscosities of Binary Mixtures of Cyclopropanecarboxylic Acid with Methanol, Ethanol, Propan-1-ol, and Butan-1-ol at Different Temperatures

Heat Capacities of Binary Mixtures of Acetic Acid with Acetic Anhydride and Methenamine at Different Temperatures

Densities and Viscosities of Binary Mixtures of Methyl 4-Chlorobutyrate with Aromatic Hydrocarbons at T = (298.15 to 318.15) K

Isobaric Heat Capacity of Potential Liquid Desiccant Solutions Containing Calcium Chloride and Its Mixtures

The study of vapor liquid equilibrium for cyclopropyl amine-methanol

Measurement and Correlation for Solubility of (S)-(+)-2,2-dimethyl-cyclopropane Carbox Amide in Different Solvents

Isobaric Heat Capacity Measurements for Dimethyl Ether and 1,1-Difluoroethane in the Liquid Phase at Temperatures from 305 K to 365 K and Pressures Up to 5 Mpa

Measurements of the Isobaric Heat Capacity of Pressurized Liquid Trans-1,3,3,3-tetrafluoropropene [r1234ze(e)] by Scanning Calorimetry

Density, Vapor Pressure, Enthalpy of Vaporization, and Heat Capacity of ( E , E )-Methyl Sorbate

Measurements and Correlations of Density, Viscosity, and Vapor Pressure for Methyl Ricinoleate

Excess Molar Enthalpies of Methylformate+(1-Propanol, 2-Propanol, 1-Butanol, 2-Butanol and 1-Pentanol) at T=298.15K, P=(5.0, 10.0)mpa, and Methylformate+1-Propanol at T=333.15K, P=10.0mpa

Determination of Vapor Pressure, Enthalpy of Vaporization, and Heat Capacity of Methyl 4- tert -Butylbenzoate

Experimental Measurements and Modeling of Density and Viscosity for Methyl Caprate + 1-Alkanol at Atmospheric Pressure and Different Temperatures

Excess Molar Enthalpies of Methyl Acetate and (1-Propanol, 2-Propanol, 1-Butanol, 2-Butanol, and 1-Pentanol) at T = (298.15 and 308.15) K and P = (5.0 and 10.0) MPa

Measurement and Correlation of the Density, Viscosity and Vapor Pressure of Fatty Acid 2-Ethyhexyl Esters

Excess Molar Enthalpies of Ethylformate and (1-Propanol, 2-Propanol, 1-Butanol, 2-Butanol, and 1-Pentanol) at T = (298.15 and 308.15) K and P = (5 and 10) Mpa

Determination of vapor heat capacities of acetone-chloroform, benzene-carbon tetrachloride and benzene-ethanol binary systems

Vapor Heat Capacities of Acetic Acid + 4-Methyl-2-pentanone, at Atmospheric Pressure

Vapor Heat Capacity of Binary and Ternary Systems

The Vapor Heat Capacities of Acetone-Chloroform, Benzene-Carbon Tetrachloride and Benzene-Ethanol Binary Mixtures