Abstract:Using a high-temperature flow calorimeter, we determined the molar heat capacities at constant pressureCp, mof four binary mixtures at three different temperatures (410.3, 514.7, and 630.6) K and various compositions. The binaries investigated are: (benzene+tetrachloromethane), (benzene+trichloromethane), (benzene+acetone), and (acetone+trichloromethane). AtT630.6 K, all these mixtures showed ideal gas behavior,i.e.heat capacity additivity. However, excess heat capacities were found at lower temperatures, particularly in (Lewis base+acidic proton) and (non-polar+polar) binary systems, such as (acetone+trichloromethane), (benzene+acetone), and (benzene+trichloromethane), but no significant excess heat capacities were detected in (non-polar+non-polar) systems. The excess heat capacity can be attributed to intermolecular interaction between unlike molecules. The heat capacities of the binary mixtures considered in the experiment were also calculated using both cubic (van der Waals)-type and virial-type equations of state: PR EOS and truncated virial EOS, respectively. The two EOSs gave comparable results. However, there are some statistically significant biases between the calculated results and experimental values in systems containing a polar component. This may be due to the limitations of the mixing rules used in the calculation.

Excess Molar Enthalpies of Methylformate+(1-Propanol, 2-Propanol, 1-Butanol, 2-Butanol and 1-Pentanol) at T=298.15K, P=(5.0, 10.0)mpa, and Methylformate+1-Propanol at T=333.15K, P=10.0mpa

Excess Molar Enthalpies of Ethylformate and (1-Propanol, 2-Propanol, 1-Butanol, 2-Butanol, and 1-Pentanol) at T = (298.15 and 308.15) K and P = (5 and 10) Mpa

Excess Molar Enthalpies of Methyl Acetate and (1-Propanol, 2-Propanol, 1-Butanol, 2-Butanol, and 1-Pentanol) at T = (298.15 and 308.15) K and P = (5.0 and 10.0) MPa

Excess Molar Enthalpies of Dimethyl Carbonate and (butanol Isomers and 1-Pentanol) at T = (298.15, 313.15, and 328.15) K and P = (0.1, 1.0, and 10.0) MPa

Molar excess enthalpies of ethyl acetate+alkanols at T=298.15K, p=10.0MPa

Excess Molar Enthalpies of Dimethyl Carbonate and (methanol, Ethanol, 1-Propanol, and 2-Propanol) at T = (298.15, 313.15, and 328.15) K and P = (0.1, 1.0, and 10.0) MPa

Densities and Viscosities of Binary Mixtures of Cyclopropanecarboxylic Acid with Methanol, Ethanol, Propan-1-ol, and Butan-1-ol at Different Temperatures

Densities and Viscosities of Binary Mixtures of Methyl 4-Chlorobutyrate with Aromatic Hydrocarbons at T = (298.15 to 318.15) K

Heat Capacities of Binary Mixtures of Acetic Acid with Acetic Anhydride and Methenamine at Different Temperatures

Isobaric Heat Capacity Measurements for Dimethyl Ether and 1,1-Difluoroethane in the Liquid Phase at Temperatures from 305 K to 365 K and Pressures Up to 5 Mpa

Excess Molar Enthalpies of N-Octanol N-Alkane and Isopentanol N-Dodecane Mixtures under High-Pressure

Volumetric Properties Of Binary Mixtures Of 1-Butyl-3-Methylimidazolium Chloride Plus Water Or Hydrophilic Solvents At Different Temperatures

The dilution enthalpies of formamide in mixtures of water and propanol at 298.15 K

Enthalpies of Dilution of Formamide in Aqueous Alcohol Solutions at 298.15 K

Experimental Vapor Pressure Data And A Vapor Pressure Equation For N,N-Dimethylformamide

Excess Molar Enthalpies for Binary Mixtures of Benzyl Alcohol and Heptanone Isomers at Different Temperatures

The Molar Heat Capacities of (benzene+tetrachloromethane), (benzene+trichloromethane), (benzene+acetone), and (Acetone+trichloromethane)

Enthalpic Interaction Coefficients of Formamide in Aqueous Methanol and Ethanol Solutions at 298.15 K

Excess Molar Volume and Apparent Molar Volume of Binary Mixtures of 2-Methyl-3-buten-2-ol with 1-Alcohol at 298.15 K

Measurements of the Thermal Conductivity of 1,3-Dichloro-2-propanol + N , N -Dimethylformamide in the Temperature Range from 303 to 368 K at Pressures up to 15.10 MPa

Excess Molar Volume of Binary Mixtures of Methylheptenone+Alkanols at 298.15 K