Abstract:An MIL-101(Cr) powder material was successfully prepared using the hydrothermal synthesis method, and then the original MIL-101(Cr) was combined with different mass fractions of CaCl2 using the immersion method to obtain a MIL-101(Cr)/CaCl2 composite material. The physical properties of the adsorbent were determined by X-ray powder diffraction (XRD), an N2 adsorption desorption isotherm test, and thermogravimetric analysis (TG). The water vapor adsorption performance of the metal-organic frameworks MOFs was tested with a gravimetric water vapor adsorption instrument to analyze its water vapor adsorption mechanism. Based on the SIMULINK platform in the MATLAB software, a simulation model of the coefficient of performance (COP) and cooling capacity of the adsorption refrigeration system was established, and the variation trends of the COP and cooling capacity of the adsorption refrigeration system under different evaporation/condensation/adsorption/desorption temperatures was theoretically studied. MIL101-(Cr)/CaCl2-20% was selected as the adsorption material in the adsorption refrigeration system through the physical characterization of composite materials with different CaCl2 concentrations by means of adsorption water vapor test experiments. A closed adsorption system performance test device was built based on the liquid level method. The cooling power per unit and adsorbent mass (COP and SCP) of the system were tested at different evaporation temperatures (288 K/293 K/298 K); the adsorption temperature was 298 K, the condensation temperature was 308 K, and the desorption temperature was 353 K. The experimental results showed that COP and SCP increased with the increase in the evaporation temperature. When the evaporation temperature was 298 K, the level of COP was 0.172, and the level of SCP was 136.9 W/kg. The COP and SCP of the system were tested at different adsorption temperatures (293 K/298 K/303 K); the evaporation temperature was 288 K, the condensation temperature was 308 K, and the desorption temperature was 353 K. The experimental results showed that the levels of COP and SCP decreased with the increase in the adsorption temperature. When the adsorption temperature was 293 K, the level of COP was 0.18, and the level of SCP was 142.4 W/kg.

Isobaric Heat Capacity of Potential Liquid Desiccant Solutions Containing Calcium Chloride and Its Mixtures

Isobaric Specific Heat Capacity of Typical Lithium Chloride Liquid Desiccants Using Scanning Calorimetry

A New Empirical Equation for the Specific Thermal Capacity of Aqueous LiCl Solutions in a Wide Range of Conditions

VAPOR PRESSURE MEASUREMNET OF LIQUID DESSICANTS AT LOW TEMPERATURES BY A NOVEL TECHNIQUE

Selection of Optimal Mixed Liquid Desiccants and Performance Analysis of the Liquid Desiccant Cooling System

Analysis of a Hybrid System of Adiabatic Absorption two-stage Liquid Desiccant and CO2 Transcritical Cycles

Heat Capacities of Four Promising Alternatives to Lithium Bromide Aqueous Solution in Absorption Refrigerators

Research on ratio selection of a mixed liquid desiccant: Mixed LiCl– CaCl2 solution

Measurement and analysis of physical properties of mixed liquid desiccants based on calcium chloride solution

Mass Transfer Performance Comparison of Two Commonly Used Liquid Desiccants: LiBr and LiCl Aqueous Solutions

Experimental Research on the Vapor Pressures of CaCl2–H2O and MgCl2–H2O As Working Fluids of Absorption Heat Transformers at High Temperature

Study on the Heat Transfer Characteristics of CO2 and Liquid Desiccant CaCl2 Aqueous Solution in the Gas Cooler and Evaporator

Development of A Novel Two-Stage Liquid Desiccant Dehumidification System Assisted by Cacl2 Solution Using Exergy Analysis Method

Suggested Solution Concentration for an Energy-Efficient Refrigeration System Combined with Condensation Heat-Driven Liquid Desiccant Cycle

Investigation on drying performance and alternative analysis of different liquid desiccants in compressed air drying system

Comparison Study of the Pre-Cooled and Internally Cooled Liquid Desiccant Systems with Different Working Fluids

Investigation on a Two-Stage Solar Liquid-Desiccant (libr) Dehumidification System Assisted by CaCl2 Solution

Cooling Capacity Test for MIL-101(Cr)/CaCl2 for Adsorption Refrigeration System

Performance Analysis Of Two Desiccant Solutions Dehumidification System

Experimental Investigations on Surface Vapor Pressure Models for LiCl–CaCl2 Desiccant Solutions