Abstract:This paper studies the impact and rebound behaviour of a thin-walled elastic-plastic circular ring after it impinges onto a rigid wall with initial velocity V-0 by finite element method. Through the dimensional analysis and a systematic simulation with different ring geometries and material properties, three non-dimensional parameters are identified, which dominate the impact duration and rebound velocity of the ring; and they are: (1) the ratio of wall thickness to average radius, eta=h/R; (2) the yield strain of the material, Y/E; and (3) the non-dimensional initial velocity of the ring, nu = V-0/V-Y, where V-Y = Y/(E rho)(1/2) denotes the yield velocity of the material [3].When the initial velocity is low, the impact between the ring and rigid plate remains elastic, the compression duration could be analytically obtained, and it agrees well with the numerical results, while the restitution duration is about 3/4 of the compression duration. The corresponding coefficient of restitution (COR) is found to be independent from the material property, whereas it increases from 0.75 to 0.78 when the thickness ratio changes from 1/20 to 1/40. With the increasing of initial velocity, a four-hinge crushing mode and a subsequent five-hinge mode are identified, which are different from the crushing mode of a ring under static compression. The variations of compression and restitution durations, rebound velocity and COR are discussed in detail, while some of them are compared with those of the impact of a solid ball onto a rigid wall. The effects of the ring geometry and material properties on these variables are also presented. The rebound velocity is found to reach the maximal at about a half of material's yield velocity when the initial velocity of the ring is about twice of the yield velocity, resulting in COR being 0.25 for all the materials and geometries adopted in this paper. (C) 2014 Elsevier Ltd. All rights reserved.

Unloading behavior of low velocity impact between elastic and elastic–plastic bodies

Unloading Model of Elastic–Plastic Half-Space Contacted by an Elastic Spherical Indenter

Effects of Load Configuration on Partial Slip Contact Between an Elasticplastic Sphere and a Rigid Flat

Discrete Element Method Models of Elastic and Elastoplastic Fiber Assemblies

Cohesive zone modeling for viscoplastic behavior at finite deformations

An elastic-plastic cohesive zone model for metal-ceramic interfaces at finite deformations

Unloading contact mechanics analysis of elastic–plastic fractal surface

Contact Law and Coefficient of Restitution in Elastoplastic Spheres

Impact and Rebound of an Elastic–plastic Ring on a Rigid Target

Transient Impact Response Analysis of an Elastic–plastic Beam

Experimental Study on Characterizing Damage Behavior of Thermoplastics

Impact Crushing and Rebound of Thin-Walled Hollow Spheres

A Simplified Numerical Elastic-Plastic Contact Model for Rough Surfaces

Numerical Investigation on the Loading-Delamination-unloading Behavior of Adhesive Joints

A mechanically-derived contact model for adhesive elastic-perfectly plastic particles. Part II: Contact under high compaction--adding a bulk elastic response

Plasto-elastohydrodynamic lubrication of heterogeneous materials in impact motion

A novel oblique impact model for elastic solids

Multiple sub-impacts phenomenon and influences on responses of elastic-plastic beam

Numerical and Theoretical Modeling of the Elastic-Plastic Bulging Deformation of UHMWPE Composite Laminate under High-Speed Impact

Study on characterization of moderate energy impact response of elastic-plastic plate structure

A New Method for the Dynamics Analysis of Super-Elastic-Plastic Foams under Inhomogeneous Loading and Unloading Conditions