Abstract:Under accident conditions, the sustained high temperature and high pressure (HTHP) environment within the containment structure poses a threat to the penetration seals. This study integrates finite element analysis of the mechanical properties of O-ring, both hyperelastic and viscoelastic characteristics, and an interfacial leakage model to predict the variation in O-ring leakage rates over time in HTHP environments. A series of leakage test experiments are conducted to validate the predictive model, indicating good agreement between experimental and predicted values. The effects of HTHP on non-aged O-rings (short-term service) are analyzed through mechanical simulations and leakage rate calculations. The results reveal that high temperatures positively and reversibly affect the O-ring seals, with hazardous conditions mainly resulting from over-pressurization. However, during the long-term service of aged O-rings, thermal aging caused by high temperatures significantly influences leakage rates. The thermal aging coupled with high pressure can cause material damage (such as rubber being squeezed out) and functional failures (excessive leakage rates). The long-term leakage rates of O-rings at high temperatures in further investigation exhibits a time–temperature equivalence. The master curve is plotted to derive an equation that describes the relationship between leakage rates, temperature, and time under specific pressure conditions. The equation indicates that the dimensionless leakage rate serves as an indicator of seal degradation and enables the quantitative evaluation of the long-term service life of the O-rings using the maximum allowable leakage rate. These findings are applicable within the range of accidental operating conditions for containment structures, including temperatures up to 160 °C and pressures up to 0.75 MPa.

Leak tightness tests of mechanical seal joints for HL-2M tokamak under thermal cycle loads

Experimental study on the performance of cryogenic seal structure with indium

Hot Helium Leak Test of ITER Blanket Shield Block

Research on Improving the System Sensitivity for Hot Helium Leak Test

The Wear of Seal Fins During High-Speed Rub Between Labyrinth Seal Fins and Honeycomb Stators at Different Incursion Rates.

Thermal fatigue failure behavior on Be/Cu joint of ITER first wall after enhanced heat flux test

China's Progress on Hot Helium Leak Test of ITER Shield Blocks

Thermal Hydraulic Characteristics During Ingress of Coolant and Loss of Vacuum Events in Fusion Reactors

Temperature distributions in a Tokamak vacuum vessel of fusion reactor after the loss-of-vacuum events occurred

Research on Sealing Structure and Ground Test of Lunar Sample Return Devices

A Thermohydrodynamic Analysis of Dry Gas Seals for High-Temperature Gas-Cooled Reactor

Characterization of long-term evolution of leakage rates of O-ring seals in nuclear power plant under high-temperature and high-pressure conditions

Lifetime measurement of a particular deep crack failure on a flat-type divertor mockup under cyclic high heat flux loading conditions

Numerical Investigations of Leakage Performance Degradations in Labyrinth and Flexible Seals Due to Wear

Mechanical Test on the Iter Cc and Feeder Jacket

Mechanical Seals for Primary Circuit of Nuclear Power Plants

Mechanical test on the ITER TF jacket

Numerical Investigations on Leakage Performance of the Rotating Labyrinth Honeycomb Seal

Analysis on High Temperature Strength and Sealing Behavior of U-type Seal in Steam Turbine Valves

Effect of Teeth Bending and Mushrooming Damages on Leakage Performance of a Labyrinth Seal

Sealing behavior of the HTR-10 pressure vessel flanges