Abstract:SiC/SiC ceramic matrix composites (CMCs) are widely applied in the aerospace and nuclear industries due to their excellent material nature (strength, hardness, and irradiation tolerance) at high-temperature loads. However, high-quality machining cannot be easily realized because of the anisotropic material structure and its properties. In this study, a laser water jet (LWJ) was adopted for CMCs machining. Firstly, the finite element model (FEM) was established describing a representative three-dimensional microstructure including weft yarn, warp yarn, SiC base, and the pyrolytic carbon (PyC) fiber coating. The temperature distribution, as well as its evolution rule on substrate surface under LWJ machining, was analyzed. Moreover, a single-dot ablation test was carried out to verify the accuracy of the numerical simulation model. Secondly, the variation in maximum temperatures under different laser pulse energy was obtained by means of FEM. Nonetheless, a non-negligible deviation emerged in the ablation depth of the numerical calculation and experimental results. Although the simulation results were obviously superior to the experimental results, their proportions of different machining parameters reached an agreement. This phenomenon can be explained by the processing characteristics of LWJ. Finally, single-row and multi-row scribing experiments for CMCs with 3 mm thickness were developed to clarify the processing capacity of LWJ. The experimental results indicated that single-tow scribing has a limiting value at a groove depth of 2461 μm, while complete cutting off can only be realized by multi-row scribing of LWJ. In addition, the cross-section of CMCs treated by LWJ presented a surface morphology without a recast layer, pulling out of SiC fibers, and delamination. The theoretical and experimental results can offer primary technical support for the high-quality machining of CMCs.

Investigation on high-aspect-ratio silicon carbide ceramic microchannel by using waterjet-assisted laser micromachining

Material removal and optimization of Si3N4 ceramic microgrooves with large-aspect ratio by WJALM

Coaxial helical gas assisted laser water jet machining of SiC/SiC ceramic matrix composites

Water jet guided laser grooving of SiC f /SiC ceramic matrix composites

Theoretical and Experimental Investigation on SiC/SiC Ceramic Matrix Composites Machining with Laser Water Jet

Investigation on the Coaxial-Annulus-Argon-Assisted Water-Jet-Guided Laser Machining of Hard-to-Process Materials

Experimental Investigation on Laser Micromilling of SiC Microchannels

Experimental Investigation of Water Jet-Guided Laser Micro-Hole Drilling of Cf/SiC Composites

Mechanism and morphology control of underwater femtosecond laser microgrooving of silicon carbide ceramics.

Experimental Research on Water-Jet Guided Laser Processing

Microstructure evolution and ablation mechanism of SiCf/SiC ceramic matrix composite microgrooves processed by pico-second laser

Experimental Study on Laser Assisted Milling of Sintered Silicon Nitride Ceramics

Investigation on femtosecond laser combined with dynamic wet etching machining of SiC/SiC

Simulation and Experimental Research on Water-Jet Guided Laser Cutting Silicon Wafer

Rapid High-Precision Machining of LTCC Utilizing Water-Jet Guided Laser Technology: Expanding the Horizons of Functional Ceramic Processing

A study of laser machining combined with dynamic chemical etching in micro‐hole drilling of 2.5D SiCf/SiC composites

High speed and low roughness micromachining of silicon carbide by plasma etching aided femtosecond laser processing

AWJ machining of high-volume fraction SiCp/Al composites

Surface microfabrication using coaxial waterjet assisted laser-induced plasma micromachining

Femtosecond laser micromachining of SiC ceramic structures

Modeling and optimizing of laser-assisted waterjet process parameters for near-damage-free micromachining of monocrystalline silicon