Coaxial helical gas assisted laser water jet machining of SiC/SiC ceramic matrix composites

Bai Cheng,Ye Ding,Yuan Li,Jingyi Li,Junjie Xu,Qiang Li,Lijun Yang

DOI: https://doi.org/10.1016/j.jmatprotec.2021.117067

IF: 6.3

2021-07-01

Journal of Materials Processing Technology

Abstract:<p>SiC/SiC ceramic matrix composites (CMCs) offer an excellent combination of properties at high temperature such as high specific strength, chemical inertness and irradiation tolerance. Those superior properties make CMCs beneficial for use in high-temperature structural applications that are exposed to extreme environments such as aerospace and nuclear energy. However, well machining qualities can hardly be achieved by conventional machining techniques owing to these properties. Laser water jet (LWJ) machining is a promising solution, which is capable of ablating materials with less/no heat defects, well machining precision and consistency. Nevertheless, the machining capacity of LWJ is still limited by the stability of water jet to a great extent. A water layer may form on substrate surface during the impingement of LWJ, which also sets up obstacle for sufficient ablation. Therefore, a novel coaxial helical gas atmosphere is introduced to promote the machining capacity of LWJ in this paper. A theoretical model is established to describe the gas-water two-phase flow field during the ejection and impingement of coaxial gas assisted LWJ (CGALWJ). The influences of gas component and pressure on the stable length of water jet and surface water layer status are analyzed based on numerical simulations and experiments. Scribing experiments are further carried out on CMCs substrates with thickness of 3 mm. Groove with maximum depth-to-width ratio of 13.6 as well as through cutting are realized without the drawing of SiC fibers, formation of recast layer and delamination. The theoretical and experimental results provide solid foundation for the high-quality machining of ceramic matrix composites and other hard-to-process materials.</p>

materials science, multidisciplinary,engineering, manufacturing, industrial

What problem does this paper attempt to address?

The problem that this paper attempts to solve is to improve the ability of Laser Water Jet (LWJ) to process SiC/SiC ceramic - matrix composites (CMCs). Specifically, the paper focuses on improving the stability of the water jet and the state of the surface water layer during the LWJ processing by introducing a coaxial helical gas atmosphere, so as to achieve high - quality processing results. Due to the special properties of CMCs (such as high strength at high temperatures, chemical inertness and irradiation tolerance), traditional processing techniques are difficult to achieve non - destructive and high - quality processing. Although LWJ, as a potential solution, can remove materials with fewer or no thermal defects and has good processing accuracy and consistency, its processing ability is still affected by the stability of the water jet. Therefore, the paper proposes a new method - coaxial helical gas atmosphere, aiming to improve the processing performance of LWJ by extending the stable length of the water jet and removing the accumulated water layer.