Abstract:Bimetallic composites have a wide range of application prospects in various industries. Different bonding temperatures, as one of the influencing factors, directly affect the bonding effectiveness as well as the performance and application of the materials. Using metallurgical bonding techniques ensures a strong bond at the interface of bimetallic materials, resulting in high-quality composite pipe billets. This paper describes an Incoloy825/P110 steel bimetal composite material made by the solid-liquid composite method. By utilizing ProCAST 14.5 software for simulation and deriving theoretical formulas, an initial range of temperatures for bimetallic preparation has been tentatively determined. And this temperature range will be utilized for on-site experiments to prepare bimetallic samples. After the preparation process is completed, samples will be selected. The influence of the external mold temperature on the interface bonding of Incoloy825/P110 steel solid-liquid composite material is studied using an ultra-depth three-dimensional morphology microscope and a scanning electron microscope. Through research, the optimal preheating temperature range for the solid-liquid composite outer mold of Incoloy825/P110 bimetallic composite material has been determined. The casting temperature of the inner mold has a significant impact on the interface bonding of this bimetal composite material. As the casting temperature of the inner mold increases, the interface thickness gradually increases. At lower temperatures, the interface thickness is lower and the bonding is poorer. At higher temperatures, melting may occur, leading to coarse grains at the interface. When the temperatures of the inner and outer molds are within a certain range, a new phase appears at the interface. Indeed, it increases the strength of the interface bonding. Due to co-melting of the bimetal near the interface, element migration occurs, resulting in increased Ni and Cr content at the interface and enhanced corrosion resistance.

Steel mesh skeleton composite pipe centrifugal casting polyurethane molding

Study on Centrifugal Compound Casting-hot Extrusion-Cold Rolling Process for Composite Pipe

Design of a Large Diameter Steel Reinforced Plastic Pipe

Modeling the Interfacial De-Bonding Behavior Between Steel Wire and Adhesive

Research on the Solid-Liquid Composite Casting Process of Incoloy825/P110 Steel Composite Pipe

One kind Yang Mei shaped radiant tube centrifuge casting pipe coating and preparation method alcohol

Numerical Simulation of the Pouring Process in Deep-Water Flexible Pipe End Fittings

Research on Casting Process for Embedded Internal Flow Passage Mould

Centrifugal Casting Process and Interface Control of Steel/Iron Bimetal Composite

Experimental Research and Manufacturing Technology of Heavy Gauge WPHY-80 Pipe Fitting Plate with Uniform Microstructure

Multi-layer composite wear-resistant pressure reduction pipe and manufacturing method thereof

Research on the Flexural Performance of Steel Pipe Steel Slag Powder Ultra-High-Performance Concrete Components

Surface Quality and ILSS of Glass Fiber Reinforced Polypropylene Composite Pipe Prepared by Filament Winding

Producing WC Particles Reinforced Gray Cast Iron Matrix Steel Rolled Guiding Board in Sand Mold

Low Viscosity Polyurethane Modified Epoxy Resin Grouting for Steel Ring Reinforcement of Subway Tunnel

Casting Production of the Lower Mold of the Liner of 250PNJ Rubber Pump

Design and Optimization of Casting Technology for Steel Beam

CHARACTER AND DEVELOPMENT OF HIGH STRENGTH CONCRETE FILLED STEEL TUBES

A Novel Design of Extrusion Container for Large Steel Tube Extrusion Process

Study on Corrosion Resistance of Carbon Steel/Stainless Steel Composite Pipe

Interface area morphology and formation mechanism of copper/steel composite prepared by the hot-dip casting