Abstract:Journal of Thermoplastic Composite Materials, Ahead of Print. This research investigated the optimization of CNC milling parameters on hardness and surface roughness properties resulting from variations in speed (220, 470, and 720 rpm), feed rate (200, 300, and 400 mm/min), and depth of cut (3, 5, and 7 mm) based on experimental design. This study aimed to evaluate the effects and relation of milling parameters using different end mill diameters (8 and 12 mm) for machining wood-plastic composites (WPCs). All of the experimental runs were determined by the Box-Behnken design and optimized using the response surface methodology. The findings from this study revealed that the main milling parameters significantly affected the hardness, average roughness (Ra), and mean peak-to-valley height (Rz) of the WPCs. Increasing the speed in a range from 220 to 720 rpm resulted in higher hardness values. On the other hand, the Ra and Rz was decreased. Additionally, this experimental result is different from the morphological structure and surface observation. It was seen that the CNC milling conditions using high speed at 720 rpm displayed smooth surfaces, which resulted in visible evenness on the WPC surfaces. Finally, numerical optimization is a good technique for the experimental results and the predicted values. The predicted conditions for the CNC milling process using end mill diameters of 8 and 12 mm included a speed of 720 rpm, a feed rate of 300 mm/min, and a depth of cut of 3 mm with the best desirability of 0.973 (97.30%). These conditions were verified in the response models and confirmed the optimal values from observed values for the variables included in the models. Also, these optimal conditions for the CNC milling parameters can be used on other types of WPCs with melting points of plastic higher than 180°C.

Influence of cryogenic CO2 on wood-plastic composite (WPC) turning-performance characteristics: a comparison with dry machining

Investigation of the orthogonal cutting of wood-plastic composites for obtaining better stability and quality

Machinability and Surface Quality During Milling CFRP Laminates Under Dry and Supercritical CO2-Based Cryogenic Conditions

Performance and mechanism evaluation during milling of CFRP laminates under cryogenic-based conditions

Machinability of Different Wood-Plastic Composites during Peripheral Milling

Machinability of wood fiber/polyethylene composite during orthogonal cutting

Research on cutting parameters of low-temperature liquid CO 2 assisted PCD tool turning bearing ring

Effects of Milling Methods on Cutting Performance of Wood–Plastic Composites Based on Principal Component Analysis

Effect of cooling and lubrication conditions on the variable angle milling of unidirectional CFRP with PCD Tools

Built-up edge formation mechanisms in orthogonal cutting of wood-plastic composite

Machinability of wood-plastic composites from the CNC milling process using the Box-Behnken design and response surface methodology for building applications

Research on the orthogonal cutting performance of polyethylene-based wood-plastic composite based on principal component analysis

Frictional behaviour of wood-Plastic composites against cemented carbide during sliding contact

Thermal Properties of Wood-Plastic Composites with Different Compositions

Tool wear and surface quality during milling CFRP laminates under dry and LN2-based cryogenic conditions

Machinability and chip morphology evolution of hardened stainless steel using liquid nitrogen cryogenic

The Effect of Cryogenic Treatment on Microstructure and Properties of WC–Co Cemented Carbides

Effect of Cryogenic Cooling on Mechanical Properties and Cutting Force of 6061 Aluminum Alloy

Effect of Cryogenic Cooling on Cutting Surface Integrity and Surface Functional Properties of 6061 Aluminum Alloy

Experimental Investigation on the Machinability of CFRP/Invar36 Hybrid Co-Cured Material in Turning Operations

Investigation of machining property and sustainability performance of cryogenic turning of GH605 superalloy