Abstract:Journal of Thermoplastic Composite Materials, Ahead of Print. This research investigated the optimization of CNC milling parameters on hardness and surface roughness properties resulting from variations in speed (220, 470, and 720 rpm), feed rate (200, 300, and 400 mm/min), and depth of cut (3, 5, and 7 mm) based on experimental design. This study aimed to evaluate the effects and relation of milling parameters using different end mill diameters (8 and 12 mm) for machining wood-plastic composites (WPCs). All of the experimental runs were determined by the Box-Behnken design and optimized using the response surface methodology. The findings from this study revealed that the main milling parameters significantly affected the hardness, average roughness (Ra), and mean peak-to-valley height (Rz) of the WPCs. Increasing the speed in a range from 220 to 720 rpm resulted in higher hardness values. On the other hand, the Ra and Rz was decreased. Additionally, this experimental result is different from the morphological structure and surface observation. It was seen that the CNC milling conditions using high speed at 720 rpm displayed smooth surfaces, which resulted in visible evenness on the WPC surfaces. Finally, numerical optimization is a good technique for the experimental results and the predicted values. The predicted conditions for the CNC milling process using end mill diameters of 8 and 12 mm included a speed of 720 rpm, a feed rate of 300 mm/min, and a depth of cut of 3 mm with the best desirability of 0.973 (97.30%). These conditions were verified in the response models and confirmed the optimal values from observed values for the variables included in the models. Also, these optimal conditions for the CNC milling parameters can be used on other types of WPCs with melting points of plastic higher than 180°C.

Investigation of the orthogonal cutting of wood-plastic composites for obtaining better stability and quality

Research on the orthogonal cutting performance of polyethylene-based wood-plastic composite based on principal component analysis

Built-up edge formation mechanisms in orthogonal cutting of wood-plastic composite

Investigation on Cutting Power of Wood–Plastic Composite Using Response Surface Methodology

Machinability of wood fiber/polyethylene composite during orthogonal cutting

Influence of cryogenic CO2 on wood-plastic composite (WPC) turning-performance characteristics: a comparison with dry machining

Machinability of Different Wood-Plastic Composites during Peripheral Milling

Effects of Milling Methods on Cutting Performance of Wood–Plastic Composites Based on Principal Component Analysis

Machinability of wood-plastic composites from the CNC milling process using the Box-Behnken design and response surface methodology for building applications

Surface roughness and chip morphology of wood-plastic composites manufactured via high-speed milling

Investigation on the Effects of Microstructure on Machining Unidirectional Carbon Fiber Reinforced Polymer Composites with a Modified Force Model

Numerical and experimental investigation of orthogonal cutting of carbon fiber-reinforced polyetheretherketone (CF/PEEK)

Optimization of tungsten carbide processing parameters for laser heating and ultrasonic vibration composite assisted cutting

Evaluation of Cutting Parameters on Heat-Affected Zone in Wood Plastic Composites by Pulsed Fiber Laser

Frictional behaviour of wood-Plastic composites against cemented carbide during sliding contact

An analytical approach to cutting force prediction in milling of carbon fiber reinforced polymer laminates

Cutting Force and Surface Roughness during Straight-Tooth Milling of Walnut Wood

Mechanisms and predictive force models for machining with rake face textured cutting tools under orthogonal cutting conditions

Investigation of orthogonal experiment for milling force model of carbon fiber composite material

Energy Efficiency Optimization for Machining of Wood Plastic Composite

Influence of cutting parameters on PCD tool wear during milling tungsten carbide