Abstract:Corrosion defects in steel pipes can lead to pipeline failure, and such failures can have severe impacts; thus, developing appropriate corrosion mitigation schemes to prevent them can be beneficial. To this end, the influences of variables such as the depth, length, and group spacing of corrosion defects on the failure of X80 steel pipes containing group corrosion defects were analysed in this study. Abaqus, a simulation software, was used for non-linear finite element analyses, and 52 groups corresponding to corrosions under different geometric factors were prepared. Furthermore, a pipeline failure pressure prediction model was established using 138 sets of simulations to determine the maximum von Mises stresses of pipelines subjected to internal pressures under different working conditions. Actual blast test data and error comparisons with various existing evaluation standards were conducted to verify the accuracy of the proposed model. The results revealed that an increase in the internal pressure and the changes in the depth, length, and group spacing of group corrosion defects impact the maximum von Mises stress in the pipe. Among the group corrosion defects considered, the depth of the deepest defect was found to be the most critical factor in determining the form of damage and the failure pressure of pipes containing corrosion defects. The length of corrosion defects and the axial spacing between groups of defects were found to be the secondary factors that affect the failure pressure. In an actual pipeline, group corrosion defects are expected to cause a reduction in the wall thickness and, thus, pose a threat to safety, an issue that warrants substantial attention. The results of this work can serve as a reference for assessing the failure of X80 steel pipelines containing group corrosion defects.

Corrosion prediction in high-sulfur low-pressure vent pipelines based on wall liquid phase aggregation and droplet erosion

Experimental and Numerical Analysis of the Impact of Corrosion on Pipeline Failure Pressure

Integrity Assessment of the Pipelines Containing an Isolated Corrosion Pit

CORROSION BEHAVIOR OF X70 PIPELINE STEEL AND CORROSION RATE PREDICTION UNDER THE COMBINATION OF CORROSIVE MEDIUM AND APPLIED PRESSURE

CFD-Based Erosion and Corrosion Modeling of a Pipeline with CO2-Containing Gas–Water Two-Phase Flow

Failure analysis of local effusion corrosion in small diameter gas pipeline: Experiment and numerical

Mechanical model and probability analysis of buried pipelines failure under uniform corrosion

Optimization of direct assessment technology for internal corrosion of gathering and transmission pipelines in Changqing Gas Field

Main control factors and prediction model of flow-accelerated CO2/H2S synergistic corrosion for X65 steel

Effect of the Y/T on the Burst Pressure for Corroded Pipelines with High Strength

Investigation on Multiphase Erosion–Corrosion of Elbow in LPG Desulfurization Unit

Numerical Simulation of Acid Gas Distribution and Corrosion Characteristics in Connecting Pipe of Lean/Rich Amine Heat Exchanger

Experimental and numerical simulation of erosion-corrosion of 90° steel elbow in shale gas pipeline

Numerical Predictions of Uniform CO2 Corrosion in Complex Fluid Domains Using Low Reynolds Number Models

Failure Analysis of High Strength Pipeline with Single and Multiple Corrosions

Corrosion main control factors and corrosion degree prediction charts in H2S and CO2 coexisting associated gas pipelines

Experimental and Numerical Analysis of the Impact of Corrosion on the Failure Pressure of API 5L X65 Pipeline

Predicting Erosion-Corrosion Induced by the Interactions Between Multiphase Flow and Structure in Piping System

Corrosion failure analysis of the 45-degree elbow in a natural gas gathering pipeline by experimental and numerical simulation

Finite element analysis of the failure of high-strength steel pipelines containing group corrosion defects

Failure Analysis of A Pipeline in Sour Gas Field