Abstract:Existing guidance from ASTM standards on extracting mechanical properties from uniaxial tension test data is not suitable for high-volume applications because it lacks automation. The Pacific Gas and Electric Company (PG&E) has performed over 450 uniaxial tension tests on samples extracted from dozens of distinct natural gas pipeline features in support of materials verification efforts; 144 of these tests recorded the entire deformation response up to fracture and were subsequently analyzed herein. Algorithms were developed to enable automatic, batch post-processing of the tensile data. Among the mechanical properties that this software extracts from the tensile data are the power-law hardening exponent and strength coefficient. A novel algorithm was developed to calculate these power-law parameters while accommodating the range of yielding and hardening behaviors present among the low carbon pipeline steels tested in this effort. The algorithm, presented in this brief technical note, first identifies the lower limit of the hardening region by calculating the tangent modulus of the stress–strain curve, which reaches its maximum value at the onset of strain hardening. The end of uniaxial hardening coincides with the ultimate tensile stress and the end of uniform deformation. From there the algorithm computes the power-law hardening parameters using conventional linear regression. Analysis of the data shows that this approach is more accurate than two other approaches: (1) regressing from 0.2% plastic strain to the limit load, and (2) iteratively regressing to identify the region that minimizes the regression error. The advantage of this approach, over existing methods, is observed for materials that exhibit a yield plateau. To further demonstrate the utility of the strain hardening information collected during this effort, the relationship between strain hardening exponent and ratio of yield strength to ultimate tensile strength from this data was compared to those reported in previous literature pertaining to remaining life assessments of steel line pipe. Overall, the strain hardening data obtained in this algorithm indicates greater hardening in pipeline steels than some previously published results. This algorithm has been made available as part of this paper's supplementary materials.

Parametric Study of Sleeve Repair on Wrinkled Energy Pipelines

Viscoelastic and Damage Model of Polyethylene Pipe Material for Slow Crack Growth Analysis

A parametric study of thermal and residual stress fields in lined pipe welding

Elastoplastic Pipe-Soil Interaction Analyses of Partially-Supported Jointed Water Mains

Parametric study on the mechanical behavior of submarine pipeline for deepwater S-lay operation

Thermal, metallurgical and mechanical analysis of circumferentially multi-pass welded P92 steel pipes

Evaluating Fitness-for-Service of Corroded Metal Pipelines: Structural Reliability Bases

Research On Safety Assessment Method For Pressure Pipe With Incomplete Welding Defects Under Complicated Loadings

A Damage Mechanics based Evaluation of Dynamic Fracture Resistance in Gas Pipelines

A general parametric finite element modeling and stress response analysis methods for pipeline system using the nonconforming solid element

Numerical analysis for failure estimation of compositely rehabilitated corroded pipes under operational and ultimate states

Creep Rupture Assessment of Cyclically Heated 3D Pressure Pipelines with Volumetric Defects Using a Direct Numerical Approach

Critical Buckling Strain Equations for Energy Pipelines—A Parametric Study

Computational Fluid Dynamic Analysis on Carbon Fibre Reinforced Polymer Wrapped on Defected Oil and Gas Piping System Using Solidwork Flow Simulation

Simulation of Crack Propagation in API 5L X52 Pressurized Pipes Using XFEM-Based Cohesive Segment Approach

Structural integrity analysis of pipelines with interacting corrosion defects by multiphysics modeling

Investigation of the Defect Width Effect on the Burst Capacity of Composite-Repaired Pipelines With Corrosion Defects Using Finite Element Analysis

Automated Calculation of Strain Hardening Parameters from Tensile Stress vs. Strain Data for Low Carbon Steel Exhibiting Yield Point Elongation

Theoretical and experimental study on the change of mechanical properties of pipelines before and after reel-laying

Experimental Study and Finite Element Analysis for the Installation of A Pipeline into an Existing Pipeline

Fracture Response of Steel Pipelines under Combined Tension and Bending