Abstract:Corrosion defects in steel pipes can lead to pipeline failure, and such failures can have severe impacts; thus, developing appropriate corrosion mitigation schemes to prevent them can be beneficial. To this end, the influences of variables such as the depth, length, and group spacing of corrosion defects on the failure of X80 steel pipes containing group corrosion defects were analysed in this study. Abaqus, a simulation software, was used for non-linear finite element analyses, and 52 groups corresponding to corrosions under different geometric factors were prepared. Furthermore, a pipeline failure pressure prediction model was established using 138 sets of simulations to determine the maximum von Mises stresses of pipelines subjected to internal pressures under different working conditions. Actual blast test data and error comparisons with various existing evaluation standards were conducted to verify the accuracy of the proposed model. The results revealed that an increase in the internal pressure and the changes in the depth, length, and group spacing of group corrosion defects impact the maximum von Mises stress in the pipe. Among the group corrosion defects considered, the depth of the deepest defect was found to be the most critical factor in determining the form of damage and the failure pressure of pipes containing corrosion defects. The length of corrosion defects and the axial spacing between groups of defects were found to be the secondary factors that affect the failure pressure. In an actual pipeline, group corrosion defects are expected to cause a reduction in the wall thickness and, thus, pose a threat to safety, an issue that warrants substantial attention. The results of this work can serve as a reference for assessing the failure of X80 steel pipelines containing group corrosion defects.

Investigation of the Defect Width Effect on the Burst Capacity of Composite-Repaired Pipelines With Corrosion Defects Using Finite Element Analysis

Experimental and Numerical Analysis of the Impact of Corrosion on Pipeline Failure Pressure

Continuum Damage Modeling and Progressive Failure Analysis of Carbon Fiber/epoxy Composite Pressure Vessel

Numerical Study on the Effect of Defect Length upon Burst Capacity of Composite Repaired Pipe

Study on the effect of corrosion defects on VIV behavior of marine pipe using a new defective pipe element

Investigation on Failure Mode of Short Carbon Fiber Reinforced Thermoplastic Composites Joints of Non-metallic Pipeline

Strength Differential Effect and Influence of Strength Criterion on Burst Pressure of Thin-Walled Pipelines

Effects of Defect Dimensions and Putty Properties on the Burst Performances of Steel Pipes Wrapped with CFRP Composites

Numerical analysis for failure estimation of compositely rehabilitated corroded pipes under operational and ultimate states

Mechanical Analysis and Parameter Design of CFRP-Wrapped Defected Steel Pipe

Theoretical Assessment of Burst Failure of Internally Pressurized Defect-Free Pipelines with Plastic Anisotropy

Assessment of the interaction of corrosion defects on steel pipelines under combined internal pressure and longitudinal compression using finite element analysis

Effect of the Y/T on the Burst Pressure for Corroded Pipelines with High Strength

Predicting the Failure Pressure of Pipelines Containing Nonuniform Depth Corrosion Defects Using the Finite Element Method

Analytical prediction of failure pressure for pipeline with long corrosion defect

Failure pressure analysis of corroded moderate-to-high strength pipelines

Burst capacity analysis of pipeline with multiple longitudinally aligned interacting corrosion defects subjected to internal pressure and axial compressive stress

Integrity Assessment of the Pipelines Containing an Isolated Corrosion Pit

Burst strength analysis of pressurized steel pipelines with corrosion and gouge defects

On the Influence of the Corrosion Defect Size in the Welding Bead, Heat-Affected Zone, and Base Metal in Pipeline Failure Pressure Estimation: A Finite Element Analysis Study

Finite element analysis of the failure of high-strength steel pipelines containing group corrosion defects