Performance Evaluation of Dual-Slope Digitizer for Self-Heating Compensation in Resistive Sensor

Gopal Singh,Shiraz Sohail,Ashish Dineshkumar Joshi,Tarikul Islam

DOI: https://doi.org/10.1109/tim.2023.3348896

IF: 5.6

2024-01-01

IEEE Transactions on Instrumentation and Measurement

Abstract:This study addresses the prevalent issue of self-heating (S-H) error observed in resistive sensors $(R_{X})$ when integrated with electronic circuits to produce output signals. An efficient digitizer circuit is proposed to interface $R_{X}$ and compensate for the S-H error. The circuit employs a dual-slope integrator and a comparator to generate a time sequence output signal. The input current through $R_{X}$ is maintained in the microampere range to minimize the S-H error. Additionally, a T-network is connected to the integrating capacitor to amplify the feedback path’s incoming current. The digitizer is tested for measuring in a wide range of $R_{X} 3.63$ –488.2 $\text{k}\Omega $ , with corresponding power dissipation of 0.273 mW– $2.05 ~\mu \text{W}$ , respectively. The current through $R_{X}$ ranges from 274.59 to $2.05 ~\mu \text{A}$ , and with the current boosting technique (gain ranging from 21.68 to 50.22), it requires a measurement time of 4.73–382.39 ms. This scheme reduces power dissipation by 472.6–1294.94 times compared to existing techniques, signifying a noteworthy improvement. The proposed digitizer produces accurate results with an average error of ±0.56% in experiments where negligible S-H is observed in testing.

engineering, electrical & electronic,instruments & instrumentation