Abstract:The tunneling magnetoresistance (TMR) angle sensors are employed in various applications as they offer noncontact measurement for full-circle range, consume low power, and have high sensitivity. These sensors provide sine- and cosine-natured nonlinear outputs with respect to the shaft angle. Therefore, a suitable electronic interface is required to estimate and obtain a linear indication of the shaft angle. In this article, one such interface, named, a faster digitizer for half-bridge-based TMR angle sensor (FDHTA), is discussed. The FDHTA utilizes a modified dual-slope-based technique which ensures a smaller conversion time while preserving measurement accuracy. This feature enables accurate measurement even for dynamic inputs. The FDHTA processes sine-cosine outputs from the sensor and renders a linear digital output, without using any explicit analog-to-digital converter (ADC). The measurement accuracy is least affected by a few sensor and circuit parameters. Apart from these features, a compensation technique is proposed to improve accuracy for one important sensor nonideality. The FDHTA is built on a PCB and tested extensively. The worst case nonlinearity, obtained for an ideal sensor, is 0.078%. Further, the FDHTA is found suitable for tracking dynamic inputs for shaft speeds up to 240 r/min with acceptable error. In experimentation, the output nonlinearity is observed to follow the inherent nonlinearity of the TMR angle sensing unit (SU). The FDHTA parameters such as standard deviation (SD), signal-to-noise ratio (SNR), etc., are observed to be at par or better when compared with the existing digitizers. The FDHTA can be employed for position estimation of the steering wheel, rotary valves, antenna, camera, surveillance equipment, etc.

Investigating timing properties of modern digitizers utilizing interpolating CFD algorithms and the application to digital fast-timing lifetime measurement

A New Method of Waveform Digitization Based on Time-Interleaved A/D Conversion

A High-Precision Coarse-Fine Time-to-digital Converter with the Analog-Digital Hybrid Interpolation

A 1.6-Gsps High-Resolution Waveform Digitizer Based on a Time-Interleaved Technique

A Two-Stage Interpolation Time-to-Digital Converter Implemented in 20 and 28 N·m FGPAs

Timing Optimization For Digital Pet Detector Module Based On Fpga-Only Mvt Digitizers

Research and Verification on Real-Time Interpolated Timing Algorithm Based on Waveform Digitization

Cross-Detection and Dual-Side Monitoring Schemes for FPGA-Based High-Accuracy and High-Precision Time-to-Digital Converters

Testing and Evaluation of a 20-Gsps High-Resolution Waveform Digitizer Based on TIADC Technique

Design and Offline Processing of an Ultrafast Digitizer Based on Internal Cascaded DRS4

Research on the Improvement of the Time-Interleaved High Speed Digitizer'S Resolution with Offset Dither

All-Digital Calibration of Timing Mismatch Error in Time-Interleaved Analog-to-Digital Converters.

A Time-to-digital-converter Utilizing Bits-Counters to Decode Carry-Chains and DSP48E1 Slices in a Field-Programmable-gate-array

A Digital-Background TIADC Calibration Architecture and a Fast Calibration Algorithm for Timing-Error Mismatch

A High-Throughput Vernier Time-to-Digital Converter on FPGAs with Improved Resolution Using a Bi-Time Interpolation Scheme

Research on High Performance Waveform Digitizer

An Adaptive Downsampling FPGA-Based TDC Implementation for Time Measurement Improvement

Analysis of a Faster Digitizer for Tunneling Magneto-Resistance Angle Sensor Configured in Push-Pull Natured Two Half-Bridges

A New Multilevel Interpolated TDC Method Based on a Two-Step Synchronizer

Design and Implementation of a High-resolution SRAM Timing Parameters Measuring Circuit

A High Precision Time-to-Digital Converter based on Multi-chain Interpolation with a Low Cost Artix-7 FPGA