Abstract:High-resolution and multichannel time-to-digital converters (TDCs) are needed in many electrical application systems. A new multistep fine time measurement method is proposed in this work, which is based on the delay-adjustable looped carry chains to obtain both high resolution and measurement precision. Each sub-step of the fine time measurement is assigned with a different measurement resolution in the descending order by dynamically configuring the delay line length. The time residue to be measured in the following sub-step becomes smaller, so that a finer resolution can be chosen. The overall oscillation number is the summation of the oscillation number of each sub-steps. The resolution of the TDC is determined by the last sub-step. So both high-resolution and small oscillation number (corresponding to high measurement precision) can be obtained. The TDC circuit was implemented on Stratix III field programmable gate array (FPGA) chip. Test results showed that the obtained resolution was less than 10 ps, and the measurement precision root mean square (rms) was about 13 ps. The differential nonlinearity (DNL) error and the integral nonlinearity (INL) error were in the range of −1 least significant bit (LSB) to 1 LSB without any bin calibration. The resource cost per TDC channel includes the lookup table (LUT) cost of 1064 and register cost of 318. The obtained TDC is comprehensively good considering its low resource cost and high linearity, and it is promising for multichannel TDC design.

Design and Implementation of a High-resolution SRAM Timing Parameters Measuring Circuit

A High-Precision SRAM Timing Parameter Measurement Circuit Based on Delay Line

A Two-Step Time-to-Digital Converter with 5.6ps Resolution and 1 - 4255μs Measurement Range

An On-Chip Circuit For Timing Measurement Of Sram Ip

A High-Resolution TDC Design Based on Multistep Fine Time Measurement by Utilizing Delay-Adjustable Looped Carry Chains on FPGAs

Implementation of A High-Precision and Wide-Range Time-To-Digital Converter with Three-Level Conversion Scheme

Implementation of a Clock Synchronization Chip Based on Time-to-digital and Digital-to-time Converters With a Shared DLL for Chip-Scale Atomic Clock

A 512 Kb SRAM in 65nm CMOS with Divided Bitline and Novel Two-Stage Sensing Technique

A High Resolution Time-to-Digital Converter (TDC) Based on Self-Calibrated Digital-to-Time Converter (DTC).

A 10ps 500MS/s two-channel Vernier TDC in 0.18um CMOS technology

A 10ps 500mhz Time-to-digital Converter in 0.18&#x03bc;m CMOS Technology for ADC

A 10b, 0.7ps resolution coarse-fine time-to-digital converter in 65nm CMOS using a time residue amplifier

Implementation of a High Precision Multi-Measurement Time-to-digital Convertor on a Kintex-7 FPGA

Design of TDC ASIC based on Temperature Compensation

A Hybrid Time-to-digital Converter Based on Residual Time Extraction and Amplification.

A high precision, high linearity 10 bit Digital-to-Time Converter circuit.

Design of a high-precision time-to-digital converter in an Elitestek Ti60 field-programmable-gate-array

A 8bits, 6.2ps Resolution Two-Step Time-to-digital Converter with Set-Reset-based Arbiters and Signal Tracking Mechanism

Design and Realization of High Precision Time-interval Measurement Based on FPGA

A 1.3mW 8-bit Two-step Time-to-Digital Converter

Time Measurement Circuit System Design