Abstract:This paper presents the results of research on the impact of the use of different tools and the shape of the additional rivet, on the geometric quality of the joint, the energy consumption of the forming process, the distortion of the steel samples, and the load capacity of the joints. The tests were carried out for DX51D steel sheets with a thickness of 1.5 [mm] joined by using three different sets of tools. A steel rivet with a hardness of 400HV1 and various shapes was used for the tests. In addition to the full rivet, two types of rivet were used, the first with a through hole and the second with a depth of hole of 3 [mm]. The holes in the rivet had different diameters: 1.0, 1.5, 2.0 and 2.5 [mm]. The influence of changing the shape of the rivet (hole and its diameter) on the change in forming force and energy consumption of the joining process was analyzed. The lowest forming force was achieved for a rivet with a through hole and a hole diameter of 2.5 [mm]. The lowest joint forming force was obtained for the die with movable segments. For joints made with three tool arrangements and a series with a modified rivet, the amount of sheet metal deviation was analyzed. Of the three cases of arrangement of tools used to form the joint, the largest deviation of the sheets occurred at the clinch joint formed with a solid round die. In the case of a series of clinch-rivet joints with a modified rivet, the greatest deviation of the sheets occurred for the rivet with a hole of 1.5 [mm]. Changes in the geometric structure of the joint were also studied, and changes in the surface of the sheets in the joint area were observed. The highest value of the interlock in the joint was obtained when a solid rivet was used in the clinch-riveting technology. The strength of the joints was also identified in the lap shear test and the energy consumption at failure was determined. The use of a rivet increased the maximum load capacity to almost twice that of the clinch joint.

Mechanical properties of tubular rivet-reinforced joints realized with different reinforcing loads

Investigation on Lightweight Performance of Tubular Rivet-Reinforced Joints for Joining AA5052 Sheets

Influence of thickness combinations on mechanical properties of joints produced by clinch riveting with rigid rivet

Experimental study of the static behavior of tubular N-joints

Microstructure evolution of AA5052 joint failure process and mechanical performance after reconditioning with tubular rivet

The Energy Consumption of the Process of Joining Steel Sheets with the Use of Clinching With and Without an Additional Rivet, and Analysis of Sheet Deformation and Mechanical Strength of Joints

Experimental Study on the Height-Reduced Joints to Increase the Cross-Tensile Strength

Mechanical Properties of B1500HS/AA5052 Joints by Self-Piercing Riveting

Numerical and experimental investigations of the reshaped joints with and without a rivet

Optimization of a Reshaping Rivet to Reduce the Protrusion Height and Increase the Strength of Clinched Joints

Effect of Mechanical and Solid-State Joining Characteristics on Tensile-Shear Performance of Friction Self-Piercing Riveted Aluminum Alloy AA7075-T6 Joints

Comparative Investigation of Auxiliary Processes for Increasing the Strength of Clinched Joints

Equivalent characterization of pre-strained material properties and mechanical behavior prediction of steel/aluminum self-piercing riveted joints

Mechanical Properties of the Two-Steps Clinched Joint with a Clinch-Rivet

Effect of blank holder force on joining quality of the flat clinch-rivet process

Friction forge riveting of AA7075-T6 sheets with large diameter 2117-T3 rivets

Comparative Investigation of Three Different Reforming Processes for Clinched Joint to Increase Joining Strength

Effect of edge riveting on the failure mechanism and mechanical properties of self-piercing riveted aluminium joints

Formation mechanism and mechanical strength evaluation of hybrid riveted/solid-state bonded aluminium alloy joint

Research on the Mechanical Properties of Single-Lap Rivet-Bonded Hybrid Joint Considering the Rivet Forming Process

Forming Mechanism of the Repairing Process on Clinched Joint