Abstract:This paper presents the results of research on the impact of the use of different tools and the shape of the additional rivet, on the geometric quality of the joint, the energy consumption of the forming process, the distortion of the steel samples, and the load capacity of the joints. The tests were carried out for DX51D steel sheets with a thickness of 1.5 [mm] joined by using three different sets of tools. A steel rivet with a hardness of 400HV1 and various shapes was used for the tests. In addition to the full rivet, two types of rivet were used, the first with a through hole and the second with a depth of hole of 3 [mm]. The holes in the rivet had different diameters: 1.0, 1.5, 2.0 and 2.5 [mm]. The influence of changing the shape of the rivet (hole and its diameter) on the change in forming force and energy consumption of the joining process was analyzed. The lowest forming force was achieved for a rivet with a through hole and a hole diameter of 2.5 [mm]. The lowest joint forming force was obtained for the die with movable segments. For joints made with three tool arrangements and a series with a modified rivet, the amount of sheet metal deviation was analyzed. Of the three cases of arrangement of tools used to form the joint, the largest deviation of the sheets occurred at the clinch joint formed with a solid round die. In the case of a series of clinch-rivet joints with a modified rivet, the greatest deviation of the sheets occurred for the rivet with a hole of 1.5 [mm]. Changes in the geometric structure of the joint were also studied, and changes in the surface of the sheets in the joint area were observed. The highest value of the interlock in the joint was obtained when a solid rivet was used in the clinch-riveting technology. The strength of the joints was also identified in the lap shear test and the energy consumption at failure was determined. The use of a rivet increased the maximum load capacity to almost twice that of the clinch joint.

Influence of thickness combinations on mechanical properties of joints produced by clinch riveting with rigid rivet

Mechanical properties of tubular rivet-reinforced joints realized with different reinforcing loads

Effects of sheet thickness and material on the mechanical properties of flat clinched joint

Influence of sheet thickness on mechanical behaviors of the clinched joints produced by single-point butt clinching process

Mechanical Properties of B1500HS/AA5052 Joints by Self-Piercing Riveting

The Energy Consumption of the Process of Joining Steel Sheets with the Use of Clinching With and Without an Additional Rivet, and Analysis of Sheet Deformation and Mechanical Strength of Joints

Formation mechanism and mechanical strength evaluation of hybrid riveted/solid-state bonded aluminium alloy joint

Effect of edge riveting on the failure mechanism and mechanical properties of self-piercing riveted aluminium joints

Effect of blank holder force on joining quality of the flat clinch-rivet process

Effect of process parameters on joint quality and mechanical properties of local-thickened self-piercing riveted steel and die-casting aluminum joints

Experimental and numerical investigation on the effect of process parameters on joint strength and failure behavior of self-piercing riveted steel/aluminium hybrid joints

Study of Mechanical Properties and Failure Mechanism of CFRP-Aluminum Alloy Self-Piercing Riveted-Adhesive Joints

Friction forge riveting of AA7075-T6 sheets with large diameter 2117-T3 rivets

Investigation of the Restored Joint for Aluminum Alloy

Equivalent characterization of pre-strained material properties and mechanical behavior prediction of steel/aluminum self-piercing riveted joints

Experimental and numerical investigation into tensile and cross tensile responses of CFRP/Al blind riveted-bonded hybrid joints

Research on material flow in flat clinching process and joint failure mechanism

Steel‐aluminum clinched joints mechanical properties and strength prediction under different geometric parameters

An experimental investigation on press joining mechanism and bearing behavior of single-lap composite riveted joints

Bonding mode and mechanical properties of keyhole-free friction stir rivet welded aluminum alloy joints

Effect of Adhesive Layer Thickness on Strength of Carbon-Fiber-Reinforced Plastic/Aluminum Bond-Riveted Joints