Abstract:Indentation fracture is a commonly employed technique for investigating solids' material properties and response to indentation. Subsurface lateral cracks are related to the mass lost on materials presenting brittle behaviour, and these cracks are usually observed in indentation experiments performed above critical loads. In this study, five microindentations were superimposed to evaluate the formation of lateral cracks under low loads, lower than the critical load, on soda-lime glass. Experimental tests were carried out using a standard Vickers indenter for individual indentations, revealing that radial cracks appeared for indentation forces greater than 98 mN. In comparison, lateral cracks only manifested for indentation forces exceeding 980 mN. To further investigate this phenomenon, we performed superimposition tests, consisting of seven lines, each containing five indentations. The indentation load ranged from 200 to 1000 mN, with varying relative distances between indentations in subsequent lines, thereby controlling the superimposition index from − 200 to 90%. Our findings established a direct correlation between crack formation, the degree of superimposition, and the indentation load. A single indentation performed with a load below the critical threshold did not generate sufficient stress to initiate lateral crack formation. However, with the superimposition of indentations, the interaction of the residual stress field near the previous indentation imprints induced lateral cracks even with loads five times lower than the critical threshold. These insights contribute to a deeper understanding of the mechanics involved in indentation-induced crack formation in brittle materials, with potential implications for material science and engineering applications.

In situ observation of fatigue crack propagation in soda‐lime glass with initial crack and residual stress induced by Vickers indentation under four‐point bending

Evaluation of crack initiation load of silica glass surfaces formed during subcritical crack growth

Lateral cracks in soda-lime glass under the threshold load due to the interaction of indentations

The Competing Effect of Initial Crack Depth Versus Chemical Strengthening Parameters on Apparent Fracture Toughness of Sodium Aluminosilicate Glass

Comparative Study on Crack Initiation and Propagation of Glass under Thermal Loading

Crack arrest and stress dependence of laser-induced surface damage in fused-silica and borosilicate glass

Stress-life fatigue behavior and fracture-surface morphology of a Cu-based bulk-metallic glass

Nondestructively determining local strength and residual stress of glass by Hertzian indentation

Fatigue endurance limit and crack front evolution in metallic glass

Statistical Analysis of Fracture Toughness of Soda-Lime Glass Determined by Indentation

Intermittent in-situ high-resolution X-ray microscopy of 400-nm porous glass under uniaxial compression: study of pore changes and crack formation

Nanoscale damage during fracture in silica glass

Surface damage resistance and yielding of chemically strengthened silicate glasses: From normal indentation to scratch loading

Investigation of Dynamic Multi-Cracking Behavior in PVB Laminated Glass Plates

Stress-induced Softening and Hardening in a Bulk Metallic Glass

Stress-enhanced ion diffusion at the vicinity of a crack tip as evidenced by atomic force microscopy in silicate glasses

Thermal stress analysis on laser scribing of glass

Three-dimensional thermal stress analysis on laser scribing of glass

Real-time, high-resolution study of nanocrystallization and fatigue cracking in a cyclically strained metallic glass

Cracking in polymer glasses and evolution at zero stress: Highlighting discrete long time scale relaxations

Crack path instabilities in DCDC experiments in the low speed regime