Abstract:The term Shear Transformation Zone (STZ) refers to the atomic cluster that dissipates external stress through cooperative shear. The STZ is the process that describes the local atomic rearrangement mechanism of metallic glasses (MGs). Based on the cooperative shear model (CSM), the size of an STZ has been estimated using the rate jump method (RJM), nano-scale creep method (NCM), first pop-in statistical method (FSM) and serration-flow statistic method (SSM), respectively. In the nanoindentation process, different sizes of STZs can be elicited by employing different experimental conditions (indentation depth and loading rate). In addition, different characterization methods exhibit various degrees of response to changes in the experimental conditions. In order to study the heterogeneity of the STZ of MGs using different nanoindentation methods, in this study, three types of Zr-based MGs with different Poisson's ratios were used as the research objects, and the sizes of the STZs of these amorphous alloys were calculated using the previously mentioned methods. By applying different maximum loads and loading rates, the effect of the nanoindentation test parameters on the size of the metallic glasses' STZs were characterized using different nanoindentation methods. Under the same testing conditions, the volume of the STZs was calculated using each method that exhibited improvement with the increase of the Poisson's ratio. The calculated results obtained using the RJM, NCM and SSM were found to be much greater than those obtained using the FSM. With the increase in the loading rate, the results obtained using NCM decreased, whereas the statistic method results slightly increased. At the maximum load, the STZ volume calculated using the JRM, NCM and SSM increased significantly. The FSM was not affected by the maximum load. Finally, these differences are discussed from the aspects of the calculation principles and the activation and evolution of the STZ.

Nondestructively determining local strength and residual stress of glass by Hertzian indentation

Depth-sensing Indentation Measurement and Finite Element Analysis of Residual Stress Field Near Fatigue Crack Tip

Stress-induced Softening and Hardening in a Bulk Metallic Glass

Testing effects on hardness of a Zr-based metallic glass under nanoindentation

Indentation fracture and toughness assessment for thin optical coatings on glass

Nanoindentation-induced evolution of atomic-level properties in silicate glass: Insights from molecular dynamics simulations

Effects of pre-strain on the nanoindentation behaviors of metallic glass studied by molecular dynamics simulations

Evaluating the tensile deformation and stress of hyperelastic material based on transparent indentation method

Effect of Applied Stress on the Mechanical Properties of a Zr-Cu-Ag-Al Bulk Metallic Glass with Two Different Structure States

Statistical Analysis of Fracture Toughness of Soda-Lime Glass Determined by Indentation

Quantification of degradation of nanomechanical properties around a static damage

Nanoindentation‐induced evolution of atomic‐level properties in silicate glass: Insights from molecular dynamics simulations

In Situ Characterization of Residual Stress in Glass-to-metal Seal

Role of densification in deformation behaviors of model metallic glasses under 3-D nanoindentation studied in molecular dynamics simulation

In situ observation of fatigue crack propagation in soda‐lime glass with initial crack and residual stress induced by Vickers indentation under four‐point bending

A novel method for stress evaluation in chemically strengthened glass based on micro-Raman spectroscopy

Effect of nanoindentation experimental parameters on the estimation of the plastic events in metallic glasses employing various analysis methods

Detecting residual stress on toughened glass surface by two complementary interferometers

Surface damage resistance and yielding of chemically strengthened silicate glasses: From normal indentation to scratch loading

Investigation of the residual stress-dependent hardness of amorphous alloys

Edge and boundary stress measurement in glass