A novel method for stress evaluation in chemically strengthened glass based on micro-Raman spectroscopy

Nobuaki Terakado,Ryusei Sasaki,Yoshihiro Takahashi,Takumi Fujiwara,Shuji Orihara,Yoshio Orihara

DOI: https://doi.org/10.1038/s42005-020-0305-7

2020-02-21

Communications Physics

Abstract:Abstract Chemically strengthened glass is widely used for screen protection in mobile devices, and its strengthening processes and application fields have rapidly diversified. The origin of the strength is residual compressive stress induced by ion exchange, and the stress evaluation has been performed via the photoelastic effect. However, for a deep understanding of the nature of the strength and development of stronger glasses, we need a method directly connected to atomic-scale glass structures. Here, we propose a method based on the “stuffing” effect, where we can determine the residual stress non-contactively and non-destructively with a high spatial resolution using Boson, D 1 , D 2 , and A 1 peaks in micro-Raman spectra. Finally, we show a plausible depth dependence of the residual stress.

physics, multidisciplinary

What problem does this paper attempt to address?

The problem that this paper attempts to solve is: how to develop a stress evaluation method directly related to the atomic - scale glass structure for non - contact and non - destructive evaluation of the residual compressive stress (Compressive Stress, CS) in chemically strengthened glass. Traditional evaluation methods are based on the photoelastic effect. Although they can conveniently determine CS and the Depth of Layer (DOL), these methods cannot reveal the association between CS and the atomic - scale glass structure. Therefore, the author proposes a new method based on the "filling" effect, using the Boson, D1, D2 and A1 peaks in micro - Raman spectroscopy to determine the residual stress, thereby achieving non - contact and non - destructive measurement at high spatial resolution and not being limited by the refractive index distribution and surface flatness.

Specifically, this method is implemented through the following steps:
1. **Theoretical derivation**: According to the "filling" effect, by analogy with the generation mechanism of thermal stress, a stress evaluation equation containing the average atomic volume \( V \) is proposed:
\[
\sigma(s, r)=\frac{E}{3(1 - \nu)}\left(\frac{V(s, 1)-V(s, r)}{V(s, r)}\right)+\sigma_0
\]
where \( E \) and \( \nu \) are Young's modulus and Poisson's ratio respectively, \( s \) represents the degree of ion exchange, \( r \) represents the degree of structural relaxation, and \( \sigma_0 \) is the internal tensile stress.

2. **Experimental verification**: Use commercial chemically strengthened glass (such as Corning® Gorilla® Glass 3) and melt - quenched glass for experiments. Analyze the positions and intensities of the Boson, D1, D2 and A1 peaks through micro - Raman spectroscopy, and then calculate the average atomic volume \( V \), the degree of ion exchange \( s \) and the degree of structural relaxation \( r \).

3. **Result analysis**: Through the above parameters, use the derived equation to calculate the residual stress at different depths, and compare it with the results of the traditional photoelastic effect method to verify the effectiveness and accuracy of the new method.

In conclusion, this paper aims to provide a new stress evaluation method for chemically strengthened glass that is directly related to the atomic - scale structure, in order to make up for the deficiencies of existing methods in microstructure analysis.