Abstract:This work investigates amorphous powders' temperature distribution and densification mechanism at macroscopic and particle scales during spark plasma sintering. The evolution of contact necks between powders was studied by quasi‐in‐situ microstructure examination. Amorphous powders' contact mode changes from point contact to surface contact as sintering proceeds. The high current density concentration leads to local overheating at the particle necks. As the contact radius ratio increases, the temperature gap between the necks and the interior of the particles becomes less noticeable. In the early stage, localized high temperature and high stress around the necks significantly reduce the densification onset temperature of amorphous powders. As the relative density increases, the uneven temperature field at the particle scale disappears, while the macroscopic temperature gradient increases. The dominant densification mechanism of amorphous powders has transitioned from particle‐scale to macroscopic temperature. The sample temperature is significantly higher than the nominal sintering temperature, promoting the contribution of viscous flow to porosity elimination. This work can provide new insights into the evolution of multi‐scale temperature distribution during spark plasma sintering and its impact on the densification behavior of amorphous powders. This article is protected by copyright. All rights reserved.

Novel approach of the evaluation of electric current density during the spark plasma sintering: Effect on the densification mechanisms of B4C-based ceramics

Continuum Modeling of B4C Densification During Spark Plasma Sintering

Multi-stage spark plasma sintering to study the densification mechanisms of boron carbide

Densification and grain growth kinetics of boron carbide powder during ultrahigh temperature spark plasma sintering

Numerical Simulation of Physical Fields during Spark Plasma Sintering of Boron Carbide

Influence of Length-Scale on Stabilization of Boron Carbide in Al-based Metal Matrix Composites During Plasma Activated Sintering

Uncovering electromigration effect on densification during electrical field assisted sintering

Effect of Tungsten Carbide on Densification and Mechanical Properties of Silicon Nitride Ceramics by Spark Plasma Sintering

Microstructure and mechanical properties of spark plasma sintered SiC ceramics aided by B4C

Densification and strengthening mechanism in spark plasma sintering of B4C–VB2 ceramics via carbide boronizing

Quantitative analysis and comparison on densification kinetics and grain growth mechanisms using reactively and directly densified TiB 2 -SiC- h BN ceramics

Densification mechanism, microstructure and mechanical properties of ZrC ceramics prepared by high-pressure spark plasma sintering

The Effect of CNTs on the Spark Plasma Sintering Densification Behavior and Mechanical Properties of B4C-Si Powders

Preparation of dense B4C ceramics by spark plasma sintering of high-purity nanoparticles

Elucidating the Multi‐scale Temperature Evolution and Densification Mechanisms of Amorphous Powders during Spark Plasma Sintering: Experiments and Modeling

Influence of electric current on microstructure and electrical property of Al-doped ZnO ceramic consolidated by spark plasma sintering

Numerical simulation of heat transfer during spark plasma sintering of porous SiC

Investigation of the effect of pressure, sintering temperature and time on silicon carbide microstructure

Progress in pressureless sintering of boron carbide ceramics – a review

Influence of CNTs on the Sintering Behavior and Mechanical Properties of Boron Carbide by SPS Process

Densification and Microstructures of PbTiO3 Ceramics Prepared by Spark Plasma Sintering