Abstract:A significant fraction of the total power in highly synchronous systems is dissipated over clock networks. Hence, low-power clocking schemes are promising approaches for low-power design. We propose four novel energy recovery clocked flip-flops that enable energy recovery from the clock network, resulting in significant energy savings. The proposed flip-flops operate with a single-phase sinusoidal clock, which can be generated with high efficiency. In the TSMC 0.25-$\mu$m CMOS technology, we implemented 1024 proposed energy recovery clocked flip-flops through an H-tree clock network driven by a resonant clock-generator to generate a sinusoidal clock. Simulation results show a power reduction of 90% on the clock-tree and total power savings of up to 83% as compared to the same implementation using the conventional square-wave clocking scheme and flip-flops. Using a sinusoidal clock signal for energy recovery prevents application of existing clock gating solutions. In this paper, we also propose clock gating solutions for energy recovery clocking. Applying our clock gating to the energy recovery clocked flip-flops reduces their power by more than 1000× in the idle mode with negligible power and delay overhead in the active mode. Finally, a test chip containing two pipelined multipliers one designed with conventional square wave clocked flip-flops and the other one with the proposed energy recovery clocked flip-flops is fabricated and measured. Based on measurement results, the energy recovery clocking scheme and flip-flops show a power reduction of 71% on the clock-tree and 39% on flip-flops, resulting in an overall power savings of 25% for the multiplier chip.

Tradeoffs in Design of Low-Power Gated-Oscillator Clock and Data Recovery Circuits

Top-Down Design of a Low-Power Multi-Channel 2.5-Gbit/s/Channel Gated Oscillator Clock-Recovery Circuit

Non-Sequential Linear Cmos Phase Detector for Cdr Applications

A 3.125gbit/s CMOS Clock and Data Recovery Circuit

A 0.7-pJ/b 12.5-Gb/s Reference-Less Subsampling Clock and Data Recovery Circuit

Ultra Low-Power Clocking Scheme Using Energy Recovery and Clock Gating

A low-power 10Gb/s CMOS clock and data recovery circuit with a quarter-rate phase detector

A Low Noise Fault Tolerant Radiation Hardened 2.56 Gbps Clock-Data Recovery Circuit With High Speed Feed Forward Correction in 65 nm CMOS

A Power Scalable 2-10 Gb/s PI-based Clock Data Recovery for Multilane Applications.

180.5mbps-8gbps Dll-Based Clock And Data Recovery Circuit With Low Jitter Performance

A 4-to-10.5 Gb/s Continuous-Rate Digital Clock and Data Recovery With Automatic Frequency Acquisition

A 10-Gb/S Cmos Clock And Data Recovery Circuit Using A Secondary Delay-Locked Loop

A 10gbps Half-Rate Digital Clock And Data Recovery Circuit For 60ghz Receiver In 65nm Cmos

Delay‐locked Loop Based Clock and Data Recovery with Wide Operating Range and Low Jitter in a 65‐nm CMOS Process

A 0.32–2.7 Gb/s Reference-Less Continuous-Rate Clock and Data Recovery Circuit With Unrestricted and Fast Frequency Acquisition

A 0.2–7.1-Gb/s Low-Jitter Full-Rate Reference-Less CDR for Communication Signal Analyzers

A 5 Gb/s Low Area CDR for Embedded Clock Serial Links

A fully integral, differential, high-speed, low-power consumption CMOS recovery clock circuit

A Low-Power All-Digital GFSK Demodulator with Robust Clock Data Recovery.

A Fully-Synthesizable 10.06gbps 16.1mw Injection-Locked CDR in 28nm FDSOI.