Abstract:High performance thermal energy systems are crucial in fulfilling the growing demand of thermal energy. Consequently, numerous heat transfer enhancements have been proposed. Some of the promising methods are boiling flow heat transfer, helical coiled tube and metal foam insert. Although the performance of each strategy has been extensively studied, based on our literature review, the effectiveness of combining these strategies has not been investigated. This missing information may impede further development of efficient heat transfer systems. This study is therefore performed to investigate subcooled flow boiling heat transfer in helical tube with copper foam insert. A high-resolution three-dimensional pore scale model that considers the shape, porosity and pore density of the metal foam is developed and validated against the published experimental results. Using the model, the effect of inlet temperature, mass flux, wall heat flux, porosity, pore density and half-filled metal foam are studied. The results suggest that operating parameters have mild effects on the heat transfer performance. In contrast, porosity and pore density show significant influence in heat transfer coefficient and pressure drop. It has also been found that total heat transfer surface area and base area are better in characterizing heat transfer in pore-scale level than porosity and pore density at pore-scale level. Moreover, implementing metal foam at outer half of the tube is observed to offer slightly better heat transfer than implementing it at the inner side by around 4.8%. Overall, this study indicates that helical metal foam tubes offer the best performance at mass flux of 200 kg/m 2 ∙s with performance index of 0.72, while straight tubes with 0.90 porosity has the highest performance index of 0.66. Empirical correlations to relate dimensionless parameters to the Nusselt number and friction factor is generated. Finally, the model developed in this study can serve to provide guidelines for the upcoming studies in boiling in metal foam structure and assist in designing metal foam heat exchangers.

Experimental study on thermal and flow characteristics of metal foam heat pipe radiator

Experimental Investigation on the Heat Transfer Performance and Evaporation Temperature Fluctuation of a New-Type Metal Foam Multichannel Heat Pipe

Analysis of the Heat Transfer in Electronic Radiator Filled with Metal Foam

A Comparison of Metal-Foam Heat Exchangers to Compact Multilouver Designs for Air-Side Heat Transfer Applications

Air-side Performance of Open-Cell Metal Foams for Use in Dehumidifying Heat Exchangers

Study on heat transfer and friction characteristics in fin-tube heat exchangers used for electrical machines cooling

Experimental Study of Composite Heat Pipe Radiator in Thermal Management of Electronic Components

Experimental investigation of heat transfer and flow characteristics in finned copper foam heat sinks subjected to jet impingement cooling

Numerical analysis of the heat transfer enhancement by using metal foam

Experimental Study on the Thermal Performance of a Finned Metal Foam Heat Sink with Phase Change Material

Enhanced heat transfer performance of optimized micro-channel heat sink via forced convection in cooling metal foam attached on copper plate

Experimental Investigation on Flow Boiling Heat Transfer of R134a in a Minichannel Heatsink with Copper Foam Fins

Numerical Simulations of Fluid Flow and Heat Transfer through Aluminum and Copper Metal Foam Heat Exchanger – A Comparative Study

Flow Boiling Heat Transfer in Copper Foam Fin Microchannels with Different Fin Widths Using R134a

Performance Evaluation and Analysis of a Vertical Heat Pipe Latent Thermal Energy Storage System with Fins-Copper Foam Combination

Thermal management of power electronics with liquid cooled metal foam heat sink

Pore-scale Simulation of Forced Convection Heat Transfer under Turbulent Conditions in Open-Cell Metal Foam

Heat transfer analysis of subcooled flow boiling in copper foam helical coiled heat exchanger – A pore-scale numerical study

Experimental Investigation on Flow and Heat Transfer Performance of a Novel Heat Fin-Plate Radiator for Electronic Cooling

Experimental investigation of permeability and Darcy-Forchheimer flow transition in metal foam with high pore density

On the Efficiency of Air-Cooled Metal Foam Heat Exchangers