Abstract:Forced convection heat transfer in metal foam pipe under uniform heat flux was investigated numerically. Water has been used as the fluid medium in numerical simulations with copper metal foam. The test sample used metal foam for four cases (A, B, C, and D) by using varying thicknesses of foam along the pipe. In case (A), the pipe was completely filled with metal foam; in case (B), the pipe was partially embedded with metal foam and close to the wall; in case (C), the pipe was partially filled in the section's center; and in case (D), the pipe was partially filled in the form of three sections along the pipe. The foam employed in this study has a porosity of 0.90 and pore density ranges from (10–40) PPI. The fluid and energy transfers are simulated using the Forchheimer-extended Darcy equation and the local thermal non-equilibrium (LTNE) model. The simulation is performed using the commercial software FLUENT with specific boundary conditions. Turbulence was taken into account using the k- ε model. The results reveal that when the pipe is filled partially with metallic foam as indicated in case B, the Nusselt ratio rises due to the velocity gradient and temperature distribution is more homogenous inside the pipe led to enhancement in overall heat transfer. Also, the metallic foam 40PPI has a highly Nusselt number ratio, with a big value equal to 5.5 in case B due to the highly conductive surface area of heat transfer from the wall heated to the fluid. Additionally, the pipe in case A was completely filled with metallic foam, resulting in a bigger pressure drop than in the other cases, which increases flow resistance. The metal foam in case C, which is centered in the pipe's center, has the lowest pressure drop measurement. The 10PPI metallic foam exhibits the highest performance factor when compared to other metallic foam.

Enhanced heat transfer performance of optimized micro-channel heat sink via forced convection in cooling metal foam attached on copper plate

Air-side Performance of Open-Cell Metal Foams for Use in Dehumidifying Heat Exchangers

A Comparison of Metal-Foam Heat Exchangers to Compact Multilouver Designs for Air-Side Heat Transfer Applications

Thermohydraulic Performance Optimization of Integrated Porous Pin Fins in Microchannel Heat Sink Using Shape Optimization Coupled with NSGA

Transient Performance of a PCM-based Heat Sink with a Partially Filled Metal Foam: Effects of the Filling Height Ratio

Experimental Investigation on the Heat Transfer Performance and Evaporation Temperature Fluctuation of a New-Type Metal Foam Multichannel Heat Pipe

Pore-scale Simulation of Forced Convection Heat Transfer under Turbulent Conditions in Open-Cell Metal Foam

Experimental study on thermal and flow characteristics of metal foam heat pipe radiator

Pore-scale numerical investigation on comprehensive heat transfer performance of homogeneous and graded metal foam heat sinks based on tetrakaidecahedron cell

Flow Boiling Heat Transfer in Copper Foam Fin Microchannels with Different Fin Widths Using R134a

Effects of structure characteristics and fluid on the effective thermal conductivity of sintered copper foam

On the Efficiency of Air-Cooled Metal Foam Heat Exchangers

Wall Heat Transfer Characteristic of Parallel-plate Channel Filled with Open-cell Metal Foams in Large Flow Velocity Range

Unlocking the Thermal Efficiency of Irregular Open-Cell Metal Foams: A Computational Exploration of Flow Dynamics and Heat Transfer Phenomena

Experimental Study on the Thermal Performance of a Finned Metal Foam Heat Sink with Phase Change Material

Insight into porous fin microchannel heat sinks with improved thermo-hydraulic performance

Conjugate heat transfer enhancement in the mini-channel heat sink by realizing the optimized flow pattern

Numerical analysis of the heat transfer enhancement by using metal foam

Numerical Simulations of Fluid Flow and Heat Transfer through Aluminum and Copper Metal Foam Heat Exchanger – A Comparative Study

Experimental Study of Boiling Heat Transfer Characteristics of Metal Foam Porous-wall Mini-channels

Hybrid Mini/Micro-Channel Heat Sink Using Liquid Metal and Water As Coolants