Abstract:A thorough numerical investigation was carried out to examine the heat transfer characteristics within a rectangular channel integrated with metal foam blocks for solar air heating applications. The study employed numerical simulations using the extended Darcy–Forchheimer model with the assumption that there exist local thermal nonequilibrium conditions within the porous foam region. Four configurations, denoted as P–A, P–P, A–P, and A–A, were explored based on the presence or absence of foam blocks relative to the heated section. The study meticulously analyzed the influence of key parameters, such as the number of foam blocks (N = 1–5), permeability (quantified by pore density, ω = 10 ‐ 30 PPI ), and Reynolds number (Re = 4000 ‐ 16 , 000 ), on the thermohydraulic performance. The results were promising, indicating a significant increase in the average Nusselt number (Nu ) with the inclusion of foam blocks, albeit accompanied by an undesirable increase in the friction factor. Among the various configurations, the P–A arrangement, where porous blocks are situated at the entrance of the heating channel, exhibited superior thermal performance. Furthermore, the optimal heat transmission rate was attained with a single porous block (N = 1) in the P–A configuration, at a Reynolds number of 16,000 and high permeability (ω = 10 PPI ). Conversely, the maximum friction factor was observed with five porous blocks (N = 5) in the A–P configuration, at a Reynolds number of 4000 and low permeability (ω = 30 PPI ). The exhaustive analysis of thermohydraulic performance was evaluated using the performance evaluation criterion (PEC), which optimizes the trade‐off between increased heat transfer rate and consequent pressure loss. The P–A arrangement, particularly with higher permeability and a minimal number of porous blocks, demonstrated the highest PEC value of 2.71, representing a significant 171% improvement compared with an empty channel. This study underscores the effectiveness of strategically placing and optimizing metal foam blocks to improve the thermal performance of heat exchanger systems.

A Comparison of Metal-Foam Heat Exchangers to Compact Multilouver Designs for Air-Side Heat Transfer Applications

Air-side Performance of Open-Cell Metal Foams for Use in Dehumidifying Heat Exchangers

On the Efficiency of Air-Cooled Metal Foam Heat Exchangers

A Review of Metal Foam and Metal Matrix Composites for Heat Exchangers and Heat Sinks

Comparison of convective heat transfer in metal foam-filled channels of three different cross-sections

Performance optimization of triple tube heat exchanger using aluminum metal foam: A comprehensive numerical investigation

Numerical Simulations of Fluid Flow and Heat Transfer through Aluminum and Copper Metal Foam Heat Exchanger – A Comparative Study

Metallic foam with cross flow heat exchanger: A review of parameters, performance, and challenges

Heat transfer analysis of subcooled flow boiling in copper foam helical coiled heat exchanger – A pore-scale numerical study

Experimental study on thermal and flow characteristics of metal foam heat pipe radiator

Unlocking the Thermal Efficiency of Irregular Open-Cell Metal Foams: A Computational Exploration of Flow Dynamics and Heat Transfer Phenomena

Optimizing thermal performance in tube-in-tube heat exchangers with metal foam inserts: experimental and RSM analysis

Forced convective heat transfer performance of foam-like structures – comparison of the Weaire-Phelan and the Kelvin structures with real metal foam

Numerical Study on Fluid Flow Behavior and Heat Transfer Performance of Porous Media Manufactured by a Space Holder Method

Optimizing heat transfer within a rectangular channel through intermittent metal foam block configurations: A numerical study

Performance evaluation of coated carbon foam material in heat exchanger applications

Pore-scale Simulation of Forced Convection Heat Transfer under Turbulent Conditions in Open-Cell Metal Foam

Experimental Study of Boiling Heat Transfer Characteristics of Metal Foam Porous-wall Mini-channels

Enhanced heat transfer performance of optimized micro-channel heat sink via forced convection in cooling metal foam attached on copper plate

Experimental Study on the Thermal Performance of a Finned Metal Foam Heat Sink with Phase Change Material

Thermal management of power electronics with liquid cooled metal foam heat sink