Abstract:Introduction. Products containing WC-Co cemented tungsten carbides are commonly used in various industries. It is often operates at elevated temperatures, at which, as noted in the literature, tungsten carbides are susceptible to severe oxidation in air. However, no sufficiently accurate values of oxidation temperatures and dependence of these temperatures and the oxidation rate of tungsten carbides on the cobalt content with its wide variation have been established. The subject of the study is the oxidation process of WC-Co cemented tungsten carbides. The purpose of the work is to obtain the oxidation temperatures of WC-Co cemented tungsten carbides with different cobalt content by weight in the range of 3–20 %. Methods. The dynamics of oxidation was studied in air. Specimens of the same length were heated to a temperature of 850 °C and cooled at the same rate in the furnace of a push-rod dilatometer Netzsch 402 PC while its expansion was simultaneously recorded. The oxidation rate of the specimens was determined by the difference in its length before heating and after cooling. The values of oxidation temperatures were obtained by mathematical analysis of relationships of the expansion on temperature. Results and discussion. Experimental dependences of expansion of WC-Co cemented tungsten carbides on temperature in the range from 20 to 850 °C, and for WC-8Co – up to 1,150 °C, were obtained. The oxidation rate of WC-Co cemented tungsten carbides increased linearly with increasing concentration of tungsten carbides (decreased with increasing cobalt content). During heating, two characteristic temperatures were identified: the onset of oxidation (631±4 °C) and the transition to active oxidation (804±11 °C). The established temperatures were the same for different ratios of tungsten carbides and cobalt. The results can be used when choosing temperature conditions for products made from WC-Co cemented tungsten carbides.

Mechanism of the early stages of oxidation of WC–Co cemented carbides

Effect of (Ti,W)C/TaC addition on the early oxidation behavior of surface layer of WC-Co cemented carbides

Oxidation behavior of functionally graded cemented carbides with CoNiFeCr multi-principal-element alloy binder

Study on the oxidation of WC-Co cemented carbide under different conditions

Influences of Cr contents on oxidation behavior of WC-Co-Ni-Cr cemented carbides at 900 °C

Selective oxidation induced wear degradation in cemented carbides

A short and facile process to synthesize WC-Co cemented carbides

Oxidation temperatures of WC-Co cemented tungsten carbides

Improvement of high-temperature oxidation resistance of WC–Co–Ni alloy by Cr3C2–CeO2–WS2 mixed additives and its mechanism

Oxidation corrosion wear and lubricating mechanisms of WC particles reinforced FeCoCrNiMn high - entropy alloys coatings

Visualizing Formation of Tungsten Carbide Model Catalyst and Its Interaction with Oxygen

Microstructure and properties of ultrafine WC–Co–VC cemented carbides with different Co contents

Effect of Mo and C Additions on Eta Phase Evolution of WC-13Co Cemented Carbides

Fabrication of tungsten oxide powder from WC–Co cemented carbide scraps by oxidation behaviour

Microstructure Evolution in the Cemented Carbides Wc-Coi. Effect of the C/W Ratio on the Morphology and Defects of the Wc Grains

XPS and AES surface analysis of WC‐Co‐(Cr) cemented carbide after immersion in neutral solution

High temperature fracture mechanism of ultrafine WC-Co cemented carbides containing (Ti,W)C

Preparation and characterization of W@WCx composite powder by oxidation-vacuum carbonization process

Effect of particle size and high-energy ball milling time on microstructure and mechanical properties of WC-10Co cemented carbides with plate-like WC grains

Oxidation Behavior of Tungsten Carbide-6% Cobalt Cemented Carbide

Study of Microstructure of Coarse-grain Tungsten Carbide Composite Produced by In-Situ Metallurgy Reaction