Abstract:Metal matrix composite reinforced by ceramic particles generally demonstrated a significant improvement in strength, while its ductility is suppressed sharply due to the incompatible deformation between matrix and rigid reinforcements. In this work, the SiCp/2024Al composites particles have been used as deformable reinforcement, which has lower elastic modulus and considerable elongation. Three Al alloys (1050Al, 2024Al, and 7A60Al) have been used as the matrix, respectively. Compared with the uniformly distributed SiCp/Al composites with the same SiC particle amount (30 vol%), the deformable particle/2024Al composites showed comparable tensile strength and higher toughness. In-situ strain observation, fracture surface analysis, and finite element method simulation proved the main deformation mechanism in the composite shifts with the increase of matrix strength. For low-strength matrix, strain concentration occurred in the matrix, while for high-strength matrix, reinforcements could also undergo plastic deformation. It could be inferred that uneven strain distribution and stress localization could be alleviated, even avoided for composites with designed ductile reinforcement, which are crucial factors for composites' ductility and machinability. A semi-empirical model was derived from statistics to describe the strengthening behavior of the composites reinforced by deformable particles. Further discussion revealed that the optimal value of the ratio between the yield strength (YS) of reinforcement and the matrix (sigma py/ sigma my) exists, by which the strength of the composite reaches the maximum value. Accordingly, the optimal ratio could be rationalized by experiments that uniform strain distribution was observed in the deformable particle/2024Al composites.

Investigation of elastic modulus and morphology of reinforcement phase on the stress distribution of copper matrix composites

MODELLING THE YIELD STRENGTH AND DUCTILITY IN COMPOSITE NANOTWINNED COPPER

THE THEORITICAL RESEARCH IN THE YIELDING BEHAVIOUR OF TENSILE DEFORMATION IN SHORT FIBER REINFORCED METAL MATRIX COMPOSITE

Dependence of Initial Stress–strain Behavior on Matrix Plastic Inhomogeneity in Short Fiber-Reinforced Metal Matrix Composite

Effect of thermal residual stresses on yielding behavior under tensile or compressive loading of short fiber reinforced metal matrix composite

FINITE ELEMENT NUMERICAL ANALYSIS OF TENSILE STRESS FIELD IN SHORT FIBER REINFORCED METAL MATRIX COMPOSITE

YIELDING BEHAVIOR OF PARTICLE REINFORCED METAL MATRIX COMPOSITE

Profound Strengthening and Toughening Effect of Reinforcement Aspect Ratio in Composite with Network Architecture

Finite Element Analysis for the Transverse Mechanical Behavior of Fiber-Reinforced Three-Phase Metal-Matrix Composites

Research on Piezoresistive Effect and Random Model of Carbon Fiber Bundle

Thermal Residual Stresses and Stress Distributions under Tensile and Compressive Loadings of Short Fiber Reinforced Metal Matrix Composites

Effect of fiber arrangement on mechanical properties of short fiber reinforced composites

The effective stress and yield strength of matrix in SiCw/Al composites under loading stress

Prediction of Longitudinal Elastic Modulus of Unidirectional Short-Fiber-reinforced Composites

Strengthening mechanism of load sharing of particulate reinforcements in a metal matrix composite

Predicting the Elastoplastic Response of Fiber-Reinforced Metal Matrix Composites

Mechanical Behavior of Deformable Particles Reinforced Al Matrix Composites

Structural modeling and mechanical research of carbon nanotube reinforced aluminum matrix composites using strain gradient theory

Finite Element Analysis and Experimental Verification on Mechanical Properties of Steel Mash Reinforced HDPE Composite Materials

Numerical analysis of the transverse strengthening behavior of fiber-reinforced metal matrix composites

On the Effects of Fiber Length and Spatial Distribution on the Stiffness of Short-Fiber Reinforced Composites