Capacitive deionization chloride and fluoride removal by amine and titania-modified biochar electrodes

Hellen Stephanie,Joshua K. Burcham,Bryce Martin,David O. Wipf
DOI: https://doi.org/10.1007/s10800-024-02114-y
IF: 2.925
2024-04-14
Journal of Applied Electrochemistry
Abstract:This study examines the use of surface-modified biochar as a porous electrode material for the capacitive deionization removal of chloride and fluoride ions. Incorporation of titanium dioxide and amine groups on biochar aims to increase surface-active sites, facilitate salt ion diffusion, and improve charge efficiency and cation/anion selectivity in asymmetric capacitive deionization. Titania, amine, and activated biochar are denoted as TB , AmB , and AcB , respectively. Physical and electrochemical characterizations were performed to investigate the surface properties of fabricated materials. At the optimum TiO 2 loading of 5% ( TB-05 ), the specific capacitance of TB-05 electrode was improved by 35% at scan rate of 1 mV s –1 in comparison to the AcB electrode, despite a decrease in the specific surface area. Three different asymmetric capacitive deionization cell designs—AmB||TB-05, AcB||TB-05, and AmB||AcB—and two symmetrical cell designs—AcB||AcB and TB-05||TB-05 (anode||cathode)—were tested. A symmetric cell design TB-05||TB-05 had a NaCl removal capacity of 8.51 mg g −1 , a 42% improvement in comparison to a symmetric AcB cell (6.01 mg g −1 ). Further, an asymmetric cell AmB||TB-05 showed 67% charge efficiency improvement over symmetric AcB cell, likely due to a reduced co-ion effect. For fluoride removal, a symmetric TB-05 cell showed a removal capacity of 3.51 mg g −1 . This study promotes simple surface-modification methods to make inexpensive commercial biochar into a sustainable, and efficient electrode material available for a scale-up asymmetric capacitive deionization.
electrochemistry
What problem does this paper attempt to address?