Abstract:This article proposes a novel method for the reduction of the hydrogen embrittlement susceptibility in a low carbon steel by the introduction of the ferrite phase into the quenched-partitioned-tempered (Q-P-T) specimen. Taking the Q-P-T specimen without ferrite as the reference, the CQ-P-T and QCQ-P-T specimens containing ferrite were obtained by intercritical annealing before the Q-P-T treatment and by pre-quenching before the CQ-P-T treatment to further refine the microstructure. The susceptibility of the three kinds of specimens toward hydrogen embrittlement was evaluated by the slow strain rate tensile test. The results showed that the elongation and area reduction of the three kinds of specimens continuously decrease with the greater electrochemical precharging time, but the three kinds of specimens exhibited different susceptibility index values. Fractographic observation showed that the primary fracture modes gradually evolved from typical dimple to quasi-cleavage, quasi-cleavage mixed with intergranular cracking and then complete intergranular manner, but the evolution rate of the QCQ-P-T specimen is the lowest while that of the Q-P-T specimen is the highest. It is suggested that the ferrite may reduce the stress concentration caused by the martensitic transformation and retard the crack propagation during deformation. Refining microstructure further improves the hydrogen embrittlement resistance by trapping more hydrogen atoms at the interphase boundary, lowering their density in the lattice.

Preparation of metallographic specimen of superficial ferrite by using low carbon steel

Preparation Method for Metallographic Specimen of Iron-Carbon and Silicon-aluminium Alloy

Dynamic recrystallization of ferrite in a low-carbon steel

A New Process to Fabricate Ultrafine-Grained Low-Carbon Steel with High Strength and High Elongation

Preparation and microstructural characterization of hard bainite in surface layer of low-carbon alloy steel

Preparation of FeAl Coating on P110 Steel at Low Temperature

Characterization of ultra-low carbon steel: A preliminary approach to investigate the quality and standards of locally-available steel

Formation of needle like proeutectiod ferrite and its influence on medium carbon steel wire properties

Colored metallography of bainite steel

Three-Dimensional Morphology and Growth Behavior of Acicular Ferrite in Low Carbon Steel Weld

A Novel Method for the Development of a Low-Temperature Bainitic Microstructure in the Surface Layer of Low-Carbon Steel

The Netted Ferrite at Grain Boundaries in the Steels with Thermomechanical Processing

Introducing ultrafine ferrite in low-temperature bainitic steel through a novel process for simultaneously improving strength and toughness

Preparation and Microstructure Characteristics of Low-Temperature Bainite in Surface Layer of Low Carbon Gear Steel

Effect of Ferrite on the Hydrogen Embrittlement in Quenched-Partitioned-tempered Low Carbon Steel

The Study of Ferrosilicon Alloy Sediment Horizon Metallographic Etchant

Strengthening of Low Carbon Steel by Nano-sized Vanadium Carbide in Ferrite and Tempered Martensite

Difference in recrystallization behavior between lath martensite and deformed ferrite in ultralow carbon steel

Influence of Prior Austenite Deformation and Non-Metallic Inclusions on Ferrite Formation in Low-Carbon Steels

Study on Three-Dimensional Morphology of Intragranular Nucleating Ferrites in Low Carbon Steels

Preparation Of Nanostructured Bainite In Medium-Carbon Alloy Steel