Abstract:Lithium is an important strategic metal and new energy material, and its development and utilization has attracted extensive attention worldwide. There are huge amounts of lithium resources in high salinity brines especially in salt lake brines and underground brines. It is necessary to accurately determine lithium content during the development of these resources. However, high concentrations of Na+, K+ , Ca2+ and Mg2+ in brines will result in serious interference with the determination of trace lithium. Inductively coupled plasma optical emission spectrometry (ICP-OES) has the ability of multi-element simultaneous analysis with wide linear range. In order to realize swift and accurate determination of lithium in brines, the analysis of lithium in high salinity samples by ICP-OES was carried out in detail in this work. Results showed that lithium has a higher signal to noise ratio at 610. 364 nm, where no obvious spectral line interferences of Na+, K+, Ca2+, Mg2+ and Ar were presented for the determination of lithium. However, large amount of Na+, K+ and Mg2+ coexisting in the samples would lead to positive matrix interferences, while the Ca2+ caused negative interference. The internal standard method widely used to eliminate matrix interferences could not effectively solve this problem using whether yttrium or scandium as an internal standard element. Because the standard addition method involves complex operations and is not suitable for batch sample analysis, while the matrix matching method must match these interfering components with corresponding ions and thus is not suitable for the analysis of batch samples with different matrix compositions, the feasibility to match complex matrix with a single component was investigated in this work. Since NaCl widely exists in brines and has obviously sensitizing effect on lithium determination, we found after a series of studies that when the total amounts of NaCl, KCl, MgCl2 in samples were no more than 40 g.L-1, the interferences of these coexisting ions could be successfully solved by adding 10 g.L-1 NaCl into both the samples and the standard solutions. Although the negative interference of Ca2+ could not be effectively solved by this method or pre-separation by precipitation, it did not lead to obvious impact on the determination when its concentration was no more than 1. 8 g.L-1. When this method was used for the determination of three kinds of spiked samples with different matrices, the recoveries were within the range of 96. 60%similar to 104.20%. Meanwhile, the accuracy and reliability of this developed method were also demonstrated by the comparison with these obtained by the inductively coupled plasma mass spectrometry (ICP-MS) method (The relative errors varied within +/- 3. 66%). Only single NaCl was used in this proposed method to match different coexisting ions, by which it not only simplified the operation, but also realized the batch analysis of samples with different matrix compositions. Therefore, it has important significance for the swift and accurate determination of lithium in brines as well as for the development and utilization of lithium resources in brines.

Enhanced ICP-MS detection of 24 elemental impurities in complex, high matrix mineral, medicinal lanthanum carbonates according to ICH Q2 (R2)

Accurate Determination of Non-Metallic Impurities in High Purity Tetramethylammonium Hydroxide Using Inductively Coupled Plasma Tandem Mass Spectrometry

Micro-sampling, high sensitivity ETV-ICP-MS method for the determination of trace rare earth impurities in high purity lanthanum oxide

Development of a novel strategy for the quantification of ultra-trace impurity elements in high-purity magnesium using inductively coupled plasma tandem mass spectrometry

HPLC Combined with ICP-MS for the Determination of Trace Amounts of Rare Earth Impurities in High-Purity La2O3 by Using 2-Ethylhexyl Hydrogen-2-ethylhexylphosphonate Resin As a Stationary Phase

An Efficient Li Dual-Column System and High-Precision Li Isotope Measurement of High Matrix and Low-Li Samples by MC-ICP-MS

Quantification of Trace Amounts of Impurities in High Purity Cobalt by High Resolution Inductively Coupled Plasma Mass Spectrometry

Study on determination of impurities in tungsten concentrates with ICP-MS

Determination of Lithium in High Salinity Samples by Inductively Coupled Plasma Optical Emission Spectrometry (ICP-OES)

Acidification-Separation of Matrix and Determinationof Impurities in High Purity Selenium by ICP-MS

Analysis of Impurity Elements in High Purity Cobalt Powder by Inductively Coupled Plasma Tandem Mass Spectrometry

A Rapid and Simple Method for Lithium Purification and Isotopic Analysis of Geological Reference Materials by MC-ICP-MS

Determination of Rare Earth Impurities in High-purity Lanthanum Oxide Using Electrothermal Vaporization/ICP-AES after HPLC Separation

Precise Determination of Trace Elements in Geological Samples by ICP-MS Using Compromise Conditions and Fine Matrix-Matching Strategy

Analysis of Ultra-Trace Impurities in High Purity Molybdenum Powder through Inductively Coupled Plasma Tandem Mass Spectrometry

ICP-MS direct determination of trace amounts of rare earth impurities in various rare earth oxides with only one standard series

ICP-MS DETERMINATION OF ELEMENTS OF MICRO AND TRACE AMOUNTS IN LEAD GRID

Elimination of the Spectral Interference from Polyatomic Ions with Rare Earth Elements in Inductively Coupled Plasma Mass Spectrometry by Combining Algebraic Correction with Chromatographic Separation

Determination of Metal Impurity Elements in Lithium Hexafluorophosphate Using Inductively Coupled Plasma Tandem Mass Spectrometry Based on Reaction Gas Mixtures

Combined use of multiple external and internal standards in LA-ICP-MS analysis of bulk geological samples using lithium borate fused glass

Simultaneous Determination of 50 Elements in Geological Samples by ICP-MS Combined with ICP-OES