Analysis of Impurity Elements in High Purity Cobalt Powder by Inductively Coupled Plasma Tandem Mass Spectrometry

Ling Fu,Shuyun Shi,Xiaoqing Chen,Hualin Xie

DOI: https://doi.org/10.1016/j.microc.2018.03.002

IF: 5.304

2018-01-01

Microchemical Journal

Abstract:An analytical method for the determination of 26 impurity elements in high purity cobalt powder was established by inductively coupled plasma tandem mass spectrometry (ICP-MS/MS). The high purity cobalt powder was disposed by microwave digestion using a mixture of nitric acid and hydrochloric acid as the digestion reagent and then determined directly by ICP-MS/MS. In the MS/MS mode, the mass spectral interferences on the analytes by polyatomic ions could be eliminated by adding different reaction gases into the collision/reaction cell (CRC). Using O2 as the reaction gas, the mass-shift reaction of P+, S+, V+, As+, Se+ with O2 occurred, and the corresponding oxide ions generated were used for the measurement. When H2 was added to the CRC as the reaction gas, the mass-shift reaction between the interfering ions and H2 occurred. Si+ and Ca+ were determined by on-mass method. When NH3/He was added as the reaction gas, cluster ions generated by the mass-shift reaction of Ti+, Cr+, Mn+, Fe+, Ni+, Cu+, and Zn+ with NH3/He. The mass-shift method was used for determination by employing the mass-shift reaction between interfering ions and NH3/He, and Na+, Mg+, A1+, and K+ were determined by the on-mass method. The matrix effect was corrected via on-line addition of the internal standard elements. The results showed that the detection limit of analyte was in the range 0.02–97.5ng/L, and the linear correlation coefficients were ≥0.9996, showing a good linear relationship. Moreover, the spike recoveries were in the range 91.6%–109.2%. Therefore, this method is well suited for the determination of 26 impurity elements in high purity cobalt powder above 5N (≥99.999%).