Abstract:Past variations in lithium concentration and isotope ratio of seawater recorded in marine carbonates have shown great potential in tracing carbon cycles during critical climate transitions, especially coupled with the radiogenic strontium isotope system. However, acquiring reliable seawater Li isotope compositions from marine carbonates can be technically challenging because non-carbonate phases co-existed in ancient marine carbonates can easily contaminate carbonate Li signal during inappropriate sample dissolution. Each contaminant phase, including Mn oxides, clays, and silicate minerals, can have different Li isotope compositions than that preserved in the car-bonate lattice. More importantly, a significant portion of Li is adsorbed on the Mn oxides and clay minerals. This fraction is considered exchangeable and can be liberated using weak acid without destruction of mineral structure. Cleaning procedures and partial digestion have been applied to remove the exchangeable Li fraction in contaminative phases and selectively dissolve the carbonates. However, previous methods cannot be directly applied to ancient marine carbonates of various carbonate purity, which lack systematic testing on the threshold of sample purity to maintain the efficiency of the precleaning and partial digestion. Here we report an efficient sequential leaching protocol to extract primary seawater Li and Sr isotope compositions from bulk marine car-bonates. The procedure consists of pre-cleaning steps using 1 M ammonium acetate and 1 M ammonium car-bonate to completely remove the exchangeable fraction, followed by partial digestion using 0.3 M acetic acid to selectively target carbonate-bounded Li. We validate this method by mixing carbonate and contaminant end -members in different weight percentages. We found this protocol works effectively for carbonates of >80% purity. Additionally, we demonstrate filtration is necessary when separating leachates from the solids to quan-titatively avoid contaminations from non-carbonate phases. We also suggest NIST-SRM-1d to be a cross-lab carbonate standard for Li isotope analyses and report its long-term external precision (two years). To sum, we propose an effective community standard procedure to reconstruct delta 7Lisw records using ancient bulk carbonate samples.

An Efficient Li Dual-Column System and High-Precision Li Isotope Measurement of High Matrix and Low-Li Samples by MC-ICP-MS

Separation And Stable Isotopic Measurement Of Lithium In Atmosphere Aerosol Sample

Efficient purification for Li and high-precision and accuracy determination of Li isotopic compositions by MC-ICP-MS

A Rapid and Simple Method for Lithium Purification and Isotopic Analysis of Geological Reference Materials by MC-ICP-MS

Accurate Determination of Lithium Isotopic Compositions in Geological Samples by Multi-collector Inductively Coupled Plasma-Mass Spectrometry

Accurate Lithium Isotopic Analysis of Twenty Geological Reference Materials by Multi-Collector Inductively Coupled Plasma Mass Spectrometry

High Precision Measurements of Lithium Isotopic Composition at Sub-Nanogram by MC-ICP-MS with Membrane Desolvation.

Separation And Isotopic Determination Of Lithium In Natural Samples

Investigation of Nitrogen Addition, Position Effect and Mismatch Intensity Effect in Li Isotopic Analysis by Nanosecond Laser Ablation Multi-Collector Inductively Coupled Plasma Mass Spectrometry

Quantifying the Impact of Recovery During Chromatographic Purification on the Accuracy of Lithium Isotopic Determination by Multi-Collector Inductively Coupled Plasma Mass Spectrometry

Effective Use of Limestones to Reconstruct Seawater Li Isotope Compositions - A Community Standard Proposal

Optimization of analytical conditions for precise and accurate isotope analyses of Li, Mg, Fe, Cu, and Zn by MC-ICPMS

Effects of Different Cone Combinations on Accurate and Precise Determination of Li Isotopic Composition by MC-ICP-MS

A single-column and efficient procedure for separating Fe and Mg from geological materials for isotopic analyses using MC-ICP-MS

High-precision Determination of Stable Potassium and Magnesium Isotopes Utilizing Single Column Separation and Multicollector Inductively Coupled Plasma Mass Spectrometry

A new procedure for separating thallium from geological materials prior to stable isotope ratio determination by MC–ICP–MS

Efficient Separation and Accurate Isotopic Determination of Lithium in Brine

High-precision Mg isotope analyses of low-Mg rocks by MC-ICP-MS

Effects of Li Isotopic Fractionation during Ion Exchange on the Measurement Accuracy of Li Isotopes

Chromatographic Purification of Ca and Mg from Biological and Geological Samples for Isotope Analysis by MC-ICP-MS

An efficient Cd two-stage column system for high-precision determination of Cd isotopic compositions by double spike MC-ICP-MS