Effect of wheel speed and subsequent annealing on the microstructure and magnetic properties of nanocomposite Pr2Fe14B/α-Fe magnets

Zhongmin Chen,Yong Zhang,George C Hadjipanayis,Qun Chen,Baomin Ma
DOI: https://doi.org/10.1016/s0304-8853(99)00528-4
IF: 3.097
1999-11-01
Journal of Magnetism and Magnetic Materials
Abstract:Nanocomposite Pr2Fe14B/α-Fe magnets have been synthesized by melt-spinning a Pr8Fe86B6 alloy at low wheel speed in the range from 10 to 21.7m/s. Microstructural and magnetic studies showed that there is an optimum wheel speed (about 16.7m/s) at which a uniform Pr2Fe14B/α-Fe microstructure with fine α-Fe grains is developed directly from the melt. Lower speed gives larger grains for both the 2:14:1 and α-Fe, while higher speed leads to the appearance of an amorphous phase which will result in a Pr2Fe14B/α-Fe structure with larger α-Fe grains after a subsequent crystallization annealing. Magnetic properties obtained under the optimum-quenching followed by a subsequent annealing are Ms=176.6emu/g, Mr=118.2emu/g, Mr/Ms=0.67,Hc=5.4kOe and (BH)m=12.6MGOe. The coercivity and energy product are about 20% higher than those obtained by over-quenching and then annealing due to the refinement of α-Fe size which leads to an enhanced exchange coupling between Pr2Fe14B and α-Fe. The fine α-Fe development is associated with its solidification behavior characterized by higher nucleation rate and lower growth rate during the rapid solidification.
materials science, multidisciplinary,physics, condensed matter
What problem does this paper attempt to address?