Abstract:The main bottleneck in the development of the next generation of Li-ion batteries with higher energy densities, as demanded for long-range electrical mobility, is the lack of understanding and control of the reactions at the electrode-electrolyte interfaces. Reactions at the cathode side cause rapid capacity loss during cycling and represent a major issue for batteries with high-voltage cathodes, which are crucial in reaching the required energy densities. Promising candidates for use in next generation of batteries are Ni-rich Li(Ni 1-x-y Mn x Co y )O 2 (NMC) cathodes, which show high capacity, high potential, and contribute to address the geopolitical issue of decreasing the Co content in the cathode. Ni-rich NMCs exhibit similar electrochemical properties as pure LiNiO 2 and therefore LiNiO 2 thin films can be used as model systems to gain fundamental understanding of the interfacial processes that hinder the large-scale implementation of Ni-rich NMCs. Atomic layer deposition (ALD) is a suitable technique to fabricate these model systems, as it gives precise control over film thickness, uniformity, chemical composition, and crystal orientation. Previous work on LiNiO 2 by ALD is not extensively reported in literature. Moreover, films grown by a supercycle process, in which two ALD subcycles are alternated, suffered from a low Ni at.% and a large C content because of precursor ligand residues, and films fabricated using a complex multilayered approach showed severe Si contamination from the Li precursor [1]. In this contribution we report on ALD lithium nickel oxide (LNO) thin films with stoichiometries close to LiNiO 2 and low levels of contaminants. The ALD process is based on lithium hexamethyldisilazide (LiHMDS) and nickel bis( N , N ’-di- tert -butylacetamidinate) (Ni( t Bu-MeAMD) 2 ) as precursors and O 2 plasma as co-reactant. 1 ALD cycle of Li 2 O is combined with x cycles of NiO using a supercycle approach. In this contribution we explore the relation between the Ni/Li cycle ratio x and material properties of the LNO films. The growth of the LNO films is monitored by means of in-situ spectroscopic ellipsometry. The ellipsometric data of films with a high Ni/Li cycle ratio are fitted with a general oscillator model used for NiO films, while a Cauchy model was adopted in case of a low Ni/Li cycle ratio and Li 2 O films. The growth per supercycle (GPSC) of LNO shows an intermixing effect, as it does not follow the linear trend calculated from the growth per cycle (GPC) values of the individual Li 2 O and NiO ALD processes, which are 1.0 Å/cycle and 0.34 Å/cycle respectively. XPS surface measurements show that the Ni/Li atomic ratio is tuned from 0 to 10 as function of the Ni/Li cycle ratio x . Low levels of Si and N contamination, below 4% and 2% respectively, are observed. A shift of the main peak in the Ni 2p 3/2 spectrum to higher binding energies indicates a shift in oxidation state from Ni 2+ to Ni 3+ as decreases [2]. According to surface measurements, the LNO film with x =5 shows a stoichiometry close to LiNiO 2 , but depth profile measurements indicate that the Ni at.% is significantly higher in the bulk than on the surface of the films, most certainly attributed to the formation of a Li 2 CO 3 surface layer upon air exposure. Li 2 CO 3 is also present in the bulk of the LNO films, but the bulk C at.% stays below 4%. These results show that we can use ALD to fabricate a high-voltage cathode model system, which we plan to characterize in-situ and post-mortem in combination with both liquid and solid electrolytes to study the cathode-electrolyte interface. [1] Maximov et al., Energies, 13 (2020) 2345 [2] Fu et al., Applied Surface Science 441 (2018) 1048 This work is part of the ‘BatteryNL – Next Generation Batteries based on Understanding Materials Interfaces’ project (with project number NWA.1389.20.089) of the NWA research programme ‘Research on Routes by Consortia (ORC)’ funded by the Dutch Research Council (NWO). Figure: (a) The GPSC of LNO ALD process shows an intermixing effect when comparing the experimental results with the expected GPSC based on the two processes (b) Ni 2p 3/2 XPS spectrum for different Ni/Li cycle ratios x . A shift to higher binding energies is observed with decreasing x , indicating a shift from Ni 2+ to Ni 3+ . (c) XPS surface measurements of LNO films show low levels of contaminants and a Ni/Li atomic ratio varying with the Ni/Li cycle ratio. (d) Depth profile of LNO with x =5 shows an increased Ni at.% and a low C at.% in the bulk of the film. Figure 1

Characterization of LiNiO2 by XPS

Monitoring the Formation of Nickel-Poor and Nickel-Rich Oxide Cathode Materials for Lithium-Ion Batteries with Synchrotron Radiation

Nickel Mg Kα XPS Spectra from the Physical Electronics Model 5400 Spectrometer

Cathode Materials of Li_xCo_(0.8)Ni_(0.2)O_2 for Lithium-ion Battery

Nickel Monochromated Al Kα XPS Spectra from the Physical Electronics Model 5400 Spectrometer

Surface Analysis of the Lithium-Rich Cathode Material Li<sub>1.2</sub>Mn<sub>0.54</sub>Co<sub>0.13</sub>Ni<sub>0.13</sub>Na<sub><i>x</i></sub>O<sub>2</sub> by Advanced Electron Microscopy

Chemical information from XPS: Theory and experiment for Ni(OH)2

LiOx-modification of Ni and Co3O4 surfaces: An XPS, LEIS and LEED study

A Fundamental Correlative Spectroscopic Study on Li1‐xNiO2 and NaNiO2

A fundamental correlative spectroscopic study on LixNiO2 and NaNiO2

Hard X-ray Photoemission Study on Positive Electrode Material Li(Ni1/3Mn1/3Co1/3)O2 for Lithium Ion Battery

Probing Li-Ni Cation Disorder in Li1−xNi1+x−yAlyO2 Cathode Materials by Neutron Diffraction

XPS Investigation of Co-Ni Oxidized Compounds Surface Using Peak-On-Satellite Ratio. Application to Co 20 Ni 80 Passive Layer Structure and Composition

XPS study of NiO thin films obtained by chemical vapor deposition

Observation and resonant x-ray optical interpretation of multi-atom resonant photoemission effects in O 1s emission from NiO

Synthesis and characterization of abundant Ni-doped LiNixMn2-xO4 (x = 0.1-0.5) powders by spray-drying method

Valence Band Oflinixmn2−

Main and Satellite Features in the Ni 2p XPS of NiO

Plasma-Enhanced Atomic Layer Deposition of Lithium Nickel Oxide Thin Film Model Systems

Surface Analysis of the Lithium-Rich Cathode Material Li1.2Mn0.54Co0.13Ni0.13NaxO2 by Advanced Electron Microscopy

Dual Electron Energy Loss Spectrum Imaging Of The Surfaces Of Lini0.5mn1.5o4 Cathode Material