Abstract:The main bottleneck in the development of the next generation of Li-ion batteries with higher energy densities, as demanded for long-range electrical mobility, is the lack of understanding and control of the reactions at the electrode-electrolyte interfaces. Reactions at the cathode side cause rapid capacity loss during cycling and represent a major issue for batteries with high-voltage cathodes, which are crucial in reaching the required energy densities. Promising candidates for use in next generation of batteries are Ni-rich Li(Ni 1-x-y Mn x Co y )O 2 (NMC) cathodes, which show high capacity, high potential, and contribute to address the geopolitical issue of decreasing the Co content in the cathode. Ni-rich NMCs exhibit similar electrochemical properties as pure LiNiO 2 and therefore LiNiO 2 thin films can be used as model systems to gain fundamental understanding of the interfacial processes that hinder the large-scale implementation of Ni-rich NMCs. Atomic layer deposition (ALD) is a suitable technique to fabricate these model systems, as it gives precise control over film thickness, uniformity, chemical composition, and crystal orientation. Previous work on LiNiO 2 by ALD is not extensively reported in literature. Moreover, films grown by a supercycle process, in which two ALD subcycles are alternated, suffered from a low Ni at.% and a large C content because of precursor ligand residues, and films fabricated using a complex multilayered approach showed severe Si contamination from the Li precursor [1]. In this contribution we report on ALD lithium nickel oxide (LNO) thin films with stoichiometries close to LiNiO 2 and low levels of contaminants. The ALD process is based on lithium hexamethyldisilazide (LiHMDS) and nickel bis( N , N ’-di- tert -butylacetamidinate) (Ni( t Bu-MeAMD) 2 ) as precursors and O 2 plasma as co-reactant. 1 ALD cycle of Li 2 O is combined with x cycles of NiO using a supercycle approach. In this contribution we explore the relation between the Ni/Li cycle ratio x and material properties of the LNO films. The growth of the LNO films is monitored by means of in-situ spectroscopic ellipsometry. The ellipsometric data of films with a high Ni/Li cycle ratio are fitted with a general oscillator model used for NiO films, while a Cauchy model was adopted in case of a low Ni/Li cycle ratio and Li 2 O films. The growth per supercycle (GPSC) of LNO shows an intermixing effect, as it does not follow the linear trend calculated from the growth per cycle (GPC) values of the individual Li 2 O and NiO ALD processes, which are 1.0 Å/cycle and 0.34 Å/cycle respectively. XPS surface measurements show that the Ni/Li atomic ratio is tuned from 0 to 10 as function of the Ni/Li cycle ratio x . Low levels of Si and N contamination, below 4% and 2% respectively, are observed. A shift of the main peak in the Ni 2p 3/2 spectrum to higher binding energies indicates a shift in oxidation state from Ni 2+ to Ni 3+ as decreases [2]. According to surface measurements, the LNO film with x =5 shows a stoichiometry close to LiNiO 2 , but depth profile measurements indicate that the Ni at.% is significantly higher in the bulk than on the surface of the films, most certainly attributed to the formation of a Li 2 CO 3 surface layer upon air exposure. Li 2 CO 3 is also present in the bulk of the LNO films, but the bulk C at.% stays below 4%. These results show that we can use ALD to fabricate a high-voltage cathode model system, which we plan to characterize in-situ and post-mortem in combination with both liquid and solid electrolytes to study the cathode-electrolyte interface. [1] Maximov et al., Energies, 13 (2020) 2345 [2] Fu et al., Applied Surface Science 441 (2018) 1048 This work is part of the ‘BatteryNL – Next Generation Batteries based on Understanding Materials Interfaces’ project (with project number NWA.1389.20.089) of the NWA research programme ‘Research on Routes by Consortia (ORC)’ funded by the Dutch Research Council (NWO). Figure: (a) The GPSC of LNO ALD process shows an intermixing effect when comparing the experimental results with the expected GPSC based on the two processes (b) Ni 2p 3/2 XPS spectrum for different Ni/Li cycle ratios x . A shift to higher binding energies is observed with decreasing x , indicating a shift from Ni 2+ to Ni 3+ . (c) XPS surface measurements of LNO films show low levels of contaminants and a Ni/Li atomic ratio varying with the Ni/Li cycle ratio. (d) Depth profile of LNO with x =5 shows an increased Ni at.% and a low C at.% in the bulk of the film. Figure 1

LiOx-modification of Ni and Co3O4 surfaces: An XPS, LEIS and LEED study

Monitoring the Formation of Nickel-Poor and Nickel-Rich Oxide Cathode Materials for Lithium-Ion Batteries with Synchrotron Radiation

Enhanced Electrochemical Performance of LiNi0.8Co0.15Al0.05O2 Cathode Material via Li2TiO3 Nanoparticles Coating

Surface Analysis of the Lithium-Rich Cathode Material Li<sub>1.2</sub>Mn<sub>0.54</sub>Co<sub>0.13</sub>Ni<sub>0.13</sub>Na<sub><i>x</i></sub>O<sub>2</sub> by Advanced Electron Microscopy

New insight into the atomic structure of electrochemically delithiated O3-Li(1- x)CoO2 (0 ≤ x ≤ 0.5) nanoparticles

New insight into the atomic structure of electrochemically delithiated O3-Li(₁-x)CoO₂ (0 ≤ x ≤ 0.5) nanoparticles

Adsorption and Deposition of Li2o2 on the Pristine and Oxidized Tic Surface by First-Principles Calculation

Plasma-Enhanced Atomic Layer Deposition of Lithium Nickel Oxide Thin Film Model Systems

Stabilizing the surface of LiNi0.815Co0.15Al0.035O2 by a facile pre-oxidation-coating strategy on the precursor

Revealing Mechanism of Li 3 PO 4 Coating Suppressed Surface Oxygen Release for Commercial Ni-Rich Layered Cathodes

RevealingMechanism of Li 3 PO 4 Coating Suppressed SurfaceOxygen Release for Commercial Ni-RichLayered Cathodes

Digital Composition Control of Cobalt Nickel Oxides by ALD for the Oxygen Evolution Reaction

Surface Modification and Characterization of LiNi_(0.8)Co_(0.2)O_2

Self-healing Growth of LaNiO 3 on a Mixed-Terminated Perovskite Surface

Revealing Mechanism of Li3PO4 Coating Suppressed Surface Oxygen Release for Commercial Ni-Rich Layered Cathodes

Research on LiNi_xMn_(2-x)O_4 Surface Modification of LiCoO_2 As Cathode Materials for Li-ion Batteries

Enhanced cycling stability of single-crystal LiNi0.83Co0.07Mn0.10O2 by Li-reactive coating with H3BO3

Direct Elimination of Detrimental Surface Phases Parasitic to LiNi x Co 1− x O 2 ( x = 0.8 and 0.9) with Unique 3D Porous Structures during Synthesis

Physical Delithiation of Epitaxial LiCoO 2 Battery Cathodes as a Platform for Surface Electronic Structure Investigation

Understanding the Role of NH4F and Al2O3 Surface Co-modification on Lithium-Excess Layered Oxide Li1.2Ni0.2Mn0.6O2

Pulsed Laser Deposition and Characterization of Heteroepitaxial LiMn2O4/La0.5Sr0.5CoO3 Bilayer Thin Films As Model Lithium Ion Battery Cathodes