Abstract:Diamond-Like Carbon (DLC) is thought to be a potential material in solving heat dissipation problems in light emitting diode module packages. It is of vital importance in evaluating the thermal conductivity of DLC film deposited on a silicon substrate. In this paper, the molecular dynamics method is used to simulate the formation of a DLC film by the deposition of carbon atoms on a isilicon substrate. Tersoff potential is adopted to reproduce the structures and densities of silicon, carbon, and SiC. A silicon substrate consisting of 544 atoms is located at the bottom of the simulation domain. The substrate is kept at a temperature of 600 K through a Noose-Hover thermostat. Carbon atoms are injected into the substrate individually every 0.5 ps at an energy of 1 eV. After a 7.5 ns deposition process, a 4 nm amorphous film containing 15000 carbon atoms is formed. Injected carbon atoms and substrate silicon atoms are intermixed at the bottom layer of the deposited film while the rest of the film contains only carbon atoms. The density of the film decreases slightly with the increase of the height of the deposited film and the average density is 2.8 g/cm3. Analysis of the coordination number shows that the sp3 fraction of carbon atoms in the film also decreases with the increase of the height of the deposited film, with a maximum value of 22%. It might be caused by the continuous impacts of the subsequently injected carbon atoms on the previously formed DLC film. The thermal conductivities of the DLC film in the planar and normal directions are calculated by the Green-Kubo method. The thermal conductivity of pure diamond film is also calculated for comparison. The results show that the planar thermal conductivity of the deposited DLC film is approximately half of that of the pure diamond film with the same size. It is higher than the normal thermal conductivity of the deposited film. The thermal conductivities of the DLC film in both planar and normal directions increase with the increase of film density and sp3 fraction in the DLC film. The results indicate that the local tetrahedral structure of sp3 carbon atoms contributes to the improvement of thermal conductivity in the DLC film.

Diamond-like carbon protective anti-reflection coating for Si solar cell

Preparation of Anti-Reflective and Protective Diamond-Like Carbon Film on Si Substrate by Femto-Second Pulsed Laser Deposition

Structure and Optical Characteristics of DLC Films

Electronic-Properties of Semiconducting Diamond-Like Carbon Diamond

Characteristics of Diamond-Like Carbon Films Fabricated by Using a Filtered Vacuum Arc System for Dye-Sensitized Solar Cells

Effects of silicon doping on low-friction and high-hardness diamond-like carbon coating via filtered cathodic vacuum arc deposition

Diamond-like Carbon Film on 20 CrNiMo Steel Prepared by Hollow-Cathode Glow Discharge

Characteristics and Surface Energy of Silicon-Doped Diamond-Like Carbon Films Fabricated by Plasma Immersion Ion Implantation and Deposition

Dep Osition and Thermal Conductivity of Diamond-Like Carb on Film on a Silicon Substrate

Microstructure, mechanical, and electrochemical properties of Si/DLC coating deposited on 2024-T3 Al alloy

Electrodeposition Of Diamond-Like Amorphous Carbon Films On Si From N,N-Dimethylformamide

Preparation of hydrogenated diamond-like carbon films on conductive glass from an organic liquid using pulsed power

Deposition of nano-diamond-like carbon films by an atmospheric pressure plasma gun and diagnostic by optical emission spectrum on the process

Effects of silicon on microstructure and corrosion resistance of diamond-like-carbon film prepared on 2024 aluminum alloy by plasma-enhanced chemical vapor deposition

The properties of N-doped diamond-like carbon films prepared by helicon wave plasma chemical vapor deposition

Analysis of Mechanical and Tribological Properties of Silicon Incorporated Diamond like Carbon Nanocomposite Coating

Research Progress of Optical Application of Diamond Carbon Films and Diamond-Like Carbon Films

Biocompatibility of Antifogging SiO-doped Diamond-Like Carbon Laparoscope Coatings

Effect of Molybdenum Concentration and Deposition Temperature on the Structure and Tribological Properties of the Diamond-like Carbon Films

Micro-structural, electrical, and tribological properties of SiC/DLC composite coating grown by PLD on steel

Evaluation of Diamond-Like Carbon Films Electrodeposited on an Al Substrate from the Liquid Phase with Pulse-Modulated Power