Abstract:This paper evaluates surface roughness effects on the properties of a-C:H:Si coatings obtained using plasma-assisted chemical vapor deposition (PACVD). Prior to coating deposition, the surfaces of the samples were subjected to grinding (Ra = 0.25) and then polishing (Ra = 0.05) or sandblasting (Ra = 1.41). Microscopic observations, measurements of thickness, wettability, surface topography, and tribological tests were used to characterize the substrate. The coating microstructure, thickness, and chemical content were investigated using scanning electron microscopy with energy dispersive spectroscopy (EDS). The geometric structure of the surface was examined using confocal microscopy before and after tribological tests. Tribological studies used a ball-on-disk sliding configuration in reciprocating motion under dry friction and cutting oil lubrication. The values of the contact angles were indicative of surface hydrophilic characteristics. Compared with the sandblasted surfaces, the adhesion strength of the coatings deposited on the polished surfaces was found to be higher. The coatings contributed to the improvement of friction and wear parameters. Under dry friction, a-C:H:Si coating friction coefficients and linear and volumetric wear on the polished surface were reduced compared with the sandblasted surface, respectively, by 10%, 83%, and 85%. In addition, the lubricant contributed to reducing the friction coefficients of the coating applied to the sandblasted sample compared with the polished sample without the coating by about 94%. Microscopic observations of wear traces allowed the determination of wear mechanisms; in the case of Ti13Nb13Zr, it was tribochemical wear through oxidation, while in the case of coatings, scratching and microcutting dominated.

Effects of silicon doping on low-friction and high-hardness diamond-like carbon coating via filtered cathodic vacuum arc deposition

Preparation of Anti-Reflective and Protective Diamond-Like Carbon Film on Si Substrate by Femto-Second Pulsed Laser Deposition

Effect of Nitrogen Doping on the Microstructure and Thermal Stability of Diamond-Like Carbon Coatings Containing Silicon and Oxygen

Extremely Enhanced Friction and Wear Performance of Hydrogen-Free DLC Film at Elevated Temperatures Via Si Doping

Friction and Wear Performance of Hydrogenated Diamond-Like Coatings with Non-Metal Element Complex Dopants Against Alumina in Ambient Air

Analysis of Mechanical and Tribological Properties of Silicon Incorporated Diamond like Carbon Nanocomposite Coating

Effect of Silicon Doping in Cvd Diamond Films from Microcrystalline to Nanocrystalline on Wc-Co Substrates

Improving the internal stress and wear resistance of DLC film by low content Ti doping

Mechanical and tribological properties of Si and W doped diamond like carbon (DLC) under dry reciprocating sliding conditions

Microstructure and high-temperature tribological properties of Ti/Si co-doped diamond-like carbon films fabricated by twin-targets reactive HiPIMS

Binary elements (Si, Mo) co-doping strategy enhanced the tribological performance of diamond-like carbon films

Nano‐Twisted Double Helix Carbon Debris Improves the Wear Resistance of Ultra‐Thick Diamond‐Like Carbon Coatings

Preparing SiC/diamond coatings via chemical vapor deposition of SiC on diamond-coated graphite and their frictional properties

High temperature tribology behavior of silicon and nitrogen doped hydrogenated diamond-like carbon (DLC) coatings

Structural and tribological behaviours of silicon doped amorphous carbon films

Surface Roughness Effects on the Properties of Silicon-Doped Diamond-like Carbon Coatings

Nanofriction Behaviors Between Silicon-Doped Diamond-Like Carbon Films under Different Testing Conditions

Insigths into the tribochemistry of silicon-doped carbon based films by ab initio analysis of water/surface interactions

Preparation and optical properties of diamond-like carbon films doped silicon

Microstructure and Tribological Properties of Diamond-Like Carbon and Tialsicn Nanocomposite Coatings

Studies of Diamond-Like Carbon (DLC) Films Deposited on Stainless Steel Substrate with Si/SiC Intermediate Layers