Abstract:Diamond-Like Carbon (DLC) is thought to be a potential material in solving heat dissipation problems in light emitting diode module packages. It is of vital importance in evaluating the thermal conductivity of DLC film deposited on a silicon substrate. In this paper, the molecular dynamics method is used to simulate the formation of a DLC film by the deposition of carbon atoms on a isilicon substrate. Tersoff potential is adopted to reproduce the structures and densities of silicon, carbon, and SiC. A silicon substrate consisting of 544 atoms is located at the bottom of the simulation domain. The substrate is kept at a temperature of 600 K through a Noose-Hover thermostat. Carbon atoms are injected into the substrate individually every 0.5 ps at an energy of 1 eV. After a 7.5 ns deposition process, a 4 nm amorphous film containing 15000 carbon atoms is formed. Injected carbon atoms and substrate silicon atoms are intermixed at the bottom layer of the deposited film while the rest of the film contains only carbon atoms. The density of the film decreases slightly with the increase of the height of the deposited film and the average density is 2.8 g/cm3. Analysis of the coordination number shows that the sp3 fraction of carbon atoms in the film also decreases with the increase of the height of the deposited film, with a maximum value of 22%. It might be caused by the continuous impacts of the subsequently injected carbon atoms on the previously formed DLC film. The thermal conductivities of the DLC film in the planar and normal directions are calculated by the Green-Kubo method. The thermal conductivity of pure diamond film is also calculated for comparison. The results show that the planar thermal conductivity of the deposited DLC film is approximately half of that of the pure diamond film with the same size. It is higher than the normal thermal conductivity of the deposited film. The thermal conductivities of the DLC film in both planar and normal directions increase with the increase of film density and sp3 fraction in the DLC film. The results indicate that the local tetrahedral structure of sp3 carbon atoms contributes to the improvement of thermal conductivity in the DLC film.

Evaluation of Diamond-Like Carbon Films Electrodeposited on an Al Substrate from the Liquid Phase with Pulse-Modulated Power

Preparation of Anti-Reflective and Protective Diamond-Like Carbon Film on Si Substrate by Femto-Second Pulsed Laser Deposition

Evaluation of Carbon Films Electrodeposited on Different Substrates from Different Organic Solvents

Electrodeposition Of Diamond-Like Amorphous Carbon Films On Si From N,N-Dimethylformamide

Electrodeposition of Diamond-Like Carbon Films from Organic Solvents and Effects of Annealing on the Film Structure

Electronic-Properties of Semiconducting Diamond-Like Carbon Diamond

Diamond-like Carbon Film on 20 CrNiMo Steel Prepared by Hollow-Cathode Glow Discharge

Deposition of nano-diamond-like carbon films by an atmospheric pressure plasma gun and diagnostic by optical emission spectrum on the process

Diamond-Like Carbon Thin Films Deposited On Ti6al4v Alloy Surface By Plasma Gun At Atmospheric Pressure

Mechanical and Tribological Properties of Diamond-Like Carbon Films Deposited by Electron Cyclotron Resonance Microwave Plasma Chemical Vapor Deposition

Dep Osition and Thermal Conductivity of Diamond-Like Carb on Film on a Silicon Substrate

Preparation of hydrogenated diamond-like carbon films on conductive glass from an organic liquid using pulsed power

Structure and Optical Characteristics of DLC Films

Tribological Properties of Diamond-Like Carbon Films Deposited by Pulsed Laser Arc Deposition

Wear-resistance of Diamond-like Carbon Thin Films Deposited on the Metal Seal Ring Surface by Plasma Gun at an Atmospheric Pressure

Structural Characters and Tribological Properties of Diamondlike Carbon Films

Diamond‐like carbon films grown by a large‐scale direct current plasma chemical vapor deposition reactor: System design, film characteristics, and applications

Characterisation of Ultra-Thin DLC Coatings by SEM/EDX, AFM and Electrochemical Techniques

Structural Characterization And Properties Enhancement Of Diamond-Like Carbon-Films Synthesized Under Low-Energy Ne+ Bombardment

Thermal Conductive Performance of Deposited Amorphous Carbonmaterials by Molecular Dynamics Simulation

Microstructure and wettability of novel Al-containing diamond-like carbon films deposited by a hybrid sputtering system