Abstract:The SO2/NOX pollution in the flue gas of non-ferrous smelting is increasingly serious. At the same time, the accumulation of red mud (RM) in the aluminum industry and phosphorus sludge (PS) in the yellow phosphorus industry has caused serious harm to the environment. To remove SO2 and NOX from the non-ferrous smelting flue gas and realize the resource utilization of the above two solid wastes, an ultrasonic field was used in this study to strengthen the PS excited O3 process and RM wet desulfurization and denitrification process. In the process of O3 excitation, the response surface method (RSM) is used to obtain the optimal O3 excitation concentration, and the optimal reaction conditions are designed based on the response surface optimization model: T is 53.226 °C, power density is 0.4 W/cm2, PS concentration is 51.433 g/L, O3 formation concentration up to 250 ppm or more, which provides a theoretical basis for subsequent desulfurization and denitrification steps. It is proved that this study can replace the expensive traditional O3 generator and provide a basis for NOX removal in the following process. In addition, the optimum experimental conditions of ultrasonic enhanced RM desulfurization and denitrification process were also explored. Under ultrasonic frequency of 28 kHz, ultrasonic power density of 0.4 W/cm2, T of 50 °C, RM concentration of 15 g/L, and stirring intensity of 1000 rpm, the desulfurization efficiency of the reaction system can be maintained above 95 % within 250 min, and the denitrification efficiency can be maintained above 90 % within 250 min. The effect of desulfurization and denitrification in this study is much better than that of traditional methods. Finally, the reaction mechanism of ultrasonic enhanced O3 excitation and RM wet desulfurization and nitrogen removal was discussed by combining adsorption thermodynamics, isotherm, and kinetics. The results showed that the OH· free radicals generated by ultrasonic cavitation and the physical effects brought by emulsification had significant promoting effects.

Pretreated water-quenched-manganese-slag slurry for high-efficiency one-step desulfurization and denitrification

Ultrasonic-enhanced Phosphorus Sludge Excited O3 Coupled Red Mud Simultaneous Desulfurization and Denitrification

Simultaneous Removal of SO2 and NO x Using Steel Slag Slurry Combined with Ozone Oxidation

The simultaneous removal of NO and SO2 over MnO2 material via the multi-stage fluidized bed process at low temperatures

Study on Desulfurization and Denitration of with Industry Solid Waste by Microwave

Simultaneous Removal of Sulfur Dioxide and Nitrogen Oxide from Flue Gas by Phosphorus Sludge: the Performance and Absorption Mechanism

Recycling of manganese ore desulfurization slag for preparation of low-temperature NH 3 -SCR catalyst with good scale-up production performance

Novel Method for High-Performance Simultaneous Removal of NOx and SO2 by Coupling Yellow Phosphorus Emulsion with Red Mud

Manganese sulfide-sulfur and limestone autotrophic denitrification system for deep and efficient nitrate removal: Feasibility, performance and mechanism

Simultaneous removal of SO2 and NOx from flue gas by phosphorus sludge: the performance and absorption mechanism

Study on the role of copper converter slag in simultaneously removing SO2 and NO using KMnO4/copper converter slag slurry

Thermal modification of copper slag via phase transformation for simultaneous removal of SO2 and NOx from acid-making tail gas

Synergetic utilization of microwave - assisted fly ash and carbide slag for simultaneous desulfurization and denitrification: High efficiency, low cost and catalytic mechanism

High efficiency removal of NO using waste calcium carbide slag by facile KOH modification

Sodium ascorbate as additive in red mud slurry for simultaneous desulfurization and denitrification: Insights into the multiple influence factors and reaction mechanism

Mechanisms of dry flue-gas desulfurization using natural manganese oxide ores

Simultaneous Absorption of SO2 and NO from Flue Gas with KMnO4/CaCO3 Slurry

Removal of SO2 and NOx from flue gas using mud-phosphorus slurry

Investigation of Nitrogen Removal in Flue Gas Desulfurization and Denitrification Wastewater Utilizing Halophilic Activated Sludge

One-step Synthesis of Sludge-Derived MnOx Catalysts for Highly Efficient Removal of Gaseous Ozone from Industrial Flue Gas

Recent Advances in Elimination of SO<sub>2</sub> and NO<sub> <i>x</i> </sub> from Flue Gas Employing Phosphorus Sludge and Phosphate Rock