Abstract:The SO2/NOX pollution in the flue gas of non-ferrous smelting is increasingly serious. At the same time, the accumulation of red mud (RM) in the aluminum industry and phosphorus sludge (PS) in the yellow phosphorus industry has caused serious harm to the environment. To remove SO2 and NOX from the non-ferrous smelting flue gas and realize the resource utilization of the above two solid wastes, an ultrasonic field was used in this study to strengthen the PS excited O3 process and RM wet desulfurization and denitrification process. In the process of O3 excitation, the response surface method (RSM) is used to obtain the optimal O3 excitation concentration, and the optimal reaction conditions are designed based on the response surface optimization model: T is 53.226 °C, power density is 0.4 W/cm2, PS concentration is 51.433 g/L, O3 formation concentration up to 250 ppm or more, which provides a theoretical basis for subsequent desulfurization and denitrification steps. It is proved that this study can replace the expensive traditional O3 generator and provide a basis for NOX removal in the following process. In addition, the optimum experimental conditions of ultrasonic enhanced RM desulfurization and denitrification process were also explored. Under ultrasonic frequency of 28 kHz, ultrasonic power density of 0.4 W/cm2, T of 50 °C, RM concentration of 15 g/L, and stirring intensity of 1000 rpm, the desulfurization efficiency of the reaction system can be maintained above 95 % within 250 min, and the denitrification efficiency can be maintained above 90 % within 250 min. The effect of desulfurization and denitrification in this study is much better than that of traditional methods. Finally, the reaction mechanism of ultrasonic enhanced O3 excitation and RM wet desulfurization and nitrogen removal was discussed by combining adsorption thermodynamics, isotherm, and kinetics. The results showed that the OH· free radicals generated by ultrasonic cavitation and the physical effects brought by emulsification had significant promoting effects.

Simultaneous Removal of Sulfur Dioxide and Nitrogen Oxide from Flue Gas by Phosphorus Sludge: the Performance and Absorption Mechanism

Simultaneous removal of SO2 and NOx from flue gas by phosphorus sludge: the performance and absorption mechanism

Novel Method for High-Performance Simultaneous Removal of NOx and SO2 by Coupling Yellow Phosphorus Emulsion with Red Mud

Recent Advances in Elimination of SO2 and NOx from Flue Gas Employing Phosphorus Sludge and Phosphate Rock

Recent Advances in Elimination of SO<sub>2</sub> and NO<sub> <i>x</i> </sub> from Flue Gas Employing Phosphorus Sludge and Phosphate Rock

Removal of SO2 and NOx from flue gas using mud-phosphorus slurry

Ultrasonic-enhanced Phosphorus Sludge Excited O3 Coupled Red Mud Simultaneous Desulfurization and Denitrification

A NEW PROCESS OF SIMULTANEOUS REMOVAL OF SO_2 AND NO_X FROM FLUE GAS WITH PYROLUSITE SLURRY

Simultaneous Removal of SO2 and NO x Using Steel Slag Slurry Combined with Ozone Oxidation

Mechanism Investigation on Yellow Phosphorus Inducing O, O3 and OH• Radicals in Phosphate Rock Slurry for High-Efficiency NO Oxidation

Enhanced NOx absorption in flue gas by wet oxidation of red mud and phosphorus sludge

Sulfate of potash and yellow phosphorus to simultaneously remove SO2–NO and obtain a complete fertilizer

Simultaneous desulfurization and denitrification of sintering flue gas via composite absorbent

Simultaneous removal of SO2 and NOx from flue gas by wet scrubbing using a urea solution

Simultaneous Desulfurization and Denitrification from Flue Gas by Catalytic Ozonation Combined with NH3/(NH4)2S2O8 Absorption: Mechanisms and Recovery of Compound Fertilizer.

O3 oxidation combined with semi-dry method for simultaneous desulfurization and denitrification of sintering/pelletizing flue gas

The simultaneous removal of NO and SO2 over MnO2 material via the multi-stage fluidized bed process at low temperatures

Simultaneous Desulfurization and Denitrification by H2O2/FeSO4 Preoxidation Combined with Wet Flue Gas Desulfurization Postabsorption: Experimental Investigation and Process Simulation

Research progress of SO2 and NOx synergistic removal by calcium-based desulfurization

Pretreated water-quenched-manganese-slag slurry for high-efficiency one-step desulfurization and denitrification

Simultaneous Absorption of SO2 and NO from Flue Gas with KMnO4/CaCO3 Slurry