Abstract:The SO2/NOX pollution in the flue gas of non-ferrous smelting is increasingly serious. At the same time, the accumulation of red mud (RM) in the aluminum industry and phosphorus sludge (PS) in the yellow phosphorus industry has caused serious harm to the environment. To remove SO2 and NOX from the non-ferrous smelting flue gas and realize the resource utilization of the above two solid wastes, an ultrasonic field was used in this study to strengthen the PS excited O3 process and RM wet desulfurization and denitrification process. In the process of O3 excitation, the response surface method (RSM) is used to obtain the optimal O3 excitation concentration, and the optimal reaction conditions are designed based on the response surface optimization model: T is 53.226 °C, power density is 0.4 W/cm2, PS concentration is 51.433 g/L, O3 formation concentration up to 250 ppm or more, which provides a theoretical basis for subsequent desulfurization and denitrification steps. It is proved that this study can replace the expensive traditional O3 generator and provide a basis for NOX removal in the following process. In addition, the optimum experimental conditions of ultrasonic enhanced RM desulfurization and denitrification process were also explored. Under ultrasonic frequency of 28 kHz, ultrasonic power density of 0.4 W/cm2, T of 50 °C, RM concentration of 15 g/L, and stirring intensity of 1000 rpm, the desulfurization efficiency of the reaction system can be maintained above 95 % within 250 min, and the denitrification efficiency can be maintained above 90 % within 250 min. The effect of desulfurization and denitrification in this study is much better than that of traditional methods. Finally, the reaction mechanism of ultrasonic enhanced O3 excitation and RM wet desulfurization and nitrogen removal was discussed by combining adsorption thermodynamics, isotherm, and kinetics. The results showed that the OH· free radicals generated by ultrasonic cavitation and the physical effects brought by emulsification had significant promoting effects.

Synergetic utilization of microwave - assisted fly ash and carbide slag for simultaneous desulfurization and denitrification: High efficiency, low cost and catalytic mechanism

Synergetic utilization of microwave-modified fly ash and carbide slag for simultaneous desulfurization and denitrification

Study and optimization of catalytic oxidation technology in spent caustic desulfurization

Ultrasonic-enhanced Phosphorus Sludge Excited O3 Coupled Red Mud Simultaneous Desulfurization and Denitrification

High efficiency removal of NO using waste calcium carbide slag by facile KOH modification

Disposal of Low Concentration Fume with Solid Waste Modified by Microwave.

Novel Method for High-Performance Simultaneous Removal of NOx and SO2 by Coupling Yellow Phosphorus Emulsion with Red Mud

Enhancing Simultaneous Desulfurization and Denitrification Efficiency of Cement Kiln Exhaust Gas Via Co-Catalytic Fenton Oxidation Process

A Superior Liquid Phase Catalyst for Enhanced Absorption of NO2 Together with SO2 after Low Temperature Ozone Oxidation for Flue Gas Treatment

Simultaneous Absorption of SO2 and NO from Flue Gas with CaCO3 and Liquid Phase Oxidation

An Adaptive Sorbent for the Combined Desulfurization/Denitration Process Using a Powder-Particle Fluidized Bed

Treating waste with waste: Facile KHCO 3 -modified calcium carbide slag for simultaneous removal of NO and SO 2

Biomass and Coal Modification to Prepare Activated Coke for Desulfurization and Denitrification

Simultaneous Removal of SO2 and NOx by Calcium-Based Sorbent with NH3 Injection at Moderate Temperatures

High Efficient Removal Of So2 And No Of Flue Gas In A Single Fluidized Bed Reactor

Simultaneous Absorption of SO2 and NO from Flue Gas with KMnO4/CaCO3 Slurry

Simultaneous Removal of SO2 and NO x Using Steel Slag Slurry Combined with Ozone Oxidation

Simultaneous Desulfurization and Denitrification by Combined Ozone Oxidation and Chemical Scrubbing

Desulfurization and Denitrification Performance of Modified Rice Husk Ash-Carbide Slag Absorbent

Simultaneous Removal of Sulfur Dioxide and Nitrogen Oxide from Flue Gas by Phosphorus Sludge: the Performance and Absorption Mechanism

The simultaneous removal of SO2 and NO from flue gas over activated coke in a multi-stage fluidized bed at low temperature